Electro Harmonix Pocket Metal Muff Manual

Electro Harmonix Ikke kategoriseret Pocket Metal Muff

Læs gratis den danske manual til Electro Harmonix Pocket Metal Muff (6 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 13 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 7 anmeldelser. Har du et spørgsmål om Electro Harmonix Pocket Metal Muff, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/6

POCKET METAL MUFF

- DESCRIPTION -

Congratulations on your purchase of the POCKET METAL MUFF! You now

have the instant classic thrashing tone of the Metal Muff in the palm of your

hand.

- CONTROLS -

DISTORTION CONTROL adjusts the amount of input gain. –

VOLUME CONTROL sets the output level. –

SCOOP TOGGLE SWITCH provides two settings of attenuation in the –

middle frequency range. In the up position, the mid attenuation is high. In

the middle position the mid attenuation is low. In the down position there is

no mid frequency attenuation.

FOOTSWITCH Selects whether the POCKET METAL MUFF is engaged or –

bypassed. The corresponding LED will be lit when the pedal is engaged, and

dark when bypassed.

INPUT Jack – This ¼” jack is the audio input to the POCKET METAL MUFF.

OUTPUT Jack – This ¼” jack is the audio output from the POCKET METAL

MUFF. When the POCKET METAL MUFF is in Bypass mode, the OUTPUT jack

is connected to the INPUT jack through a buffer.

- OPERATION AND WARNINGS -

Power, from the internal 9-volt battery or external battery eliminator, is

activated by plugging into the input. The input cable should be removed

when the unit is not in use to avoid running down the battery. The input

impedance presented at the Input Jack is 1Mohm. The output impedance at

the Output Jack is 600 ohms.

The barrel connector on the front of the POCKET METAL MUFF is for a 9-volt

battery eliminator capable of delivering 100 mA of current. The inner ring of

the 9-volt battery eliminator must be negative, the outer ring positive.

The unit’s battery may be left in or taken out when the eliminator is in use.

To achieve its biting distortion, the POCKET METAL MUFF has very high

maximum gain. This requires that both the pickups and cables be well

shielded and properly grounded to avoid excessive hum when high sustain

control settings are used.

To change the 9-volt battery, you must remove the 4 screws on the

bottom of the METAL MUFF. Once the screws are removed, you can

take off the bottom plate and change the battery. Please do not

touch the circuit board while the bottom plate is off or you may

damage a component.

The optional 9V power supply from Electro-Harmonix is US96DC-200BI

(same as used by Boss ™ & Ibanez™) 9.6 volts/DC 200ma. The barrel

connector on the front of the POCKET METAL MUFF is for the 9-volt battery

eliminator capable of delivering 100 mA of current. The inner ring of the 9-

volt battery eliminator must be negative, the outer ring positive. The unit’s

battery may be left in or taken out when the eliminator is in use.

Produkt Specifikationer

Mærke:	Electro Harmonix
Kategori:	Ikke kategoriseret
Model:	Pocket Metal Muff

Har du brug for hjælp?

Hvis du har brug for hjælp til Electro Harmonix Pocket Metal Muff stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Electro Harmonix Manualer

Electro Harmonix Good Vibes Manual

1 Januar 2025

Electro Harmonix OD Glove Manual

29 December 2024

Electro Harmonix Soul POG Manual

29 December 2024

Electro Harmonix Memory Boy Manual

29 December 2024

Electro Harmonix Super Switcher Manual

4 December 2024

Electro Harmonix Crayon 69 Manual

18 November 2024

Electro Harmonix POG III Manual

11 Oktober 2024

Electro Harmonix Cock Fight Manual

4 September 2024

Electro Harmonix Cock Fight Plus Manual

4 September 2024

Electro Harmonix The Worm Manual

3 September 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Smeg CVI120GE Manual

17 Juni 2025

Panduit VS-CKP4-000 Manual

17 Juni 2025

Yamazen LTH-2BH Manual

17 Juni 2025

Philips ASH4511CH Manual

17 Juni 2025

Yamazen MNW-1890CJ Manual

17 Juni 2025

D-Link DMC-700SC Manual

17 Juni 2025

Makita DHP490 Manual

17 Juni 2025

Royal Catering RC-BFWH12030 Manual

17 Juni 2025

Makita TW011G Manual

17 Juni 2025

Philips 50BDL2050Q Manual

17 Juni 2025