Electro Harmonix The Worm Manual


Læs gratis den danske manual til Electro Harmonix The Worm (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 47 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 24 anmeldelser. Har du et spørgsmål om Electro Harmonix The Worm, eller vil du spørge andre brugere om produktet?

Side 1/4
The Worm
Analog Modulation Pedal
Congratulations on your purchase of
The Worm
, a multi-functional modulation pedal.
The Worm
is four analog effects in one: Modulated Wah, Phaser, Tremolo and Vibrato.
-AC ADAPTOR-
Your
Worm
comes equipped with a 24 volt DC (inner positive) / 100mA external power
adapter. Use only the power adapter that is supplied! Using the wrong adapter can cause
serious bodily injury and may damage your unit. This will void the warranty.
- CONTROLS -
MODE Rotary Switch
Selects between the four different types of effects:
WAH
,
PHASER
,
TREMOLO
and
VIBRATO
.
RANGE Knob
Adjusts the amount of effect that will be applied to your signal. As
the
RANGE
knob is turned from the Counter-Clockwise (minimum) position to the
Clockwise (maximum) position, the tensity of the effect will increase. in
RATE Knob
Adjusts the speed of modulation for the effect. As the
RATE
knob is
turned from the Counter-Clockwise (minimum) position to the Clockwise (maximum)
position, the speed of the effect will go from slow to fast.
AUTO / MANUAL/EXP Toggle Switch
Set this switch to AUTO mode for normal
modulation use. When this switch is set to MANUAL/EXP mode, the internal
modulation waveform is disconnected from the circuit and the RANGE knob will
sweep through the effect. In addition, while in MANUAL/EXP mode, you can connect
an expression pedal or control voltage (between 0 5V only) to the EXP. PEDAL jack
and use the expression pedal to sweep the effects.
STATUS LED and FOOTSWITCH
If the effect is engaged, the LED will blink at
the same rate that the effect modulates. If the LED is off, The Worm is in True
Bypass mode. The footswitch engages/disengages the effect.
- JACKS -
INPUT Jack
Connect your instrument to this jack. The input impedance present at
this jack is 300 k
.
OUTPUT Jack
Connect this jack to your amp or next effects pedal. The output
impedance present at this jack is 1 k
.
EXP. PEDAL Jack
Connect an Expression Pedal to this jack or the output from a
Control Voltage generator. The expression pedal must have a TRS plug attached to it
with the tip attached to the pedal’s wiper. The control voltage must be between 0V
and 5V. The input impedance present at this jack is 1 k00
.
Acceptable expression pedals include: M-Audio EX-P, Moog Expression Ped , Roland al
EV-5 and Boss -500L. FV
24V PWR Jack
Connect the output plug from the supplied 24VDC/100mA wall
wart to the 24V PWR jack at the top of The Worm. Please use only the AC Adapter
that came supplied with The Worm. The Worm does not accept batterie s.


Produkt Specifikationer

Mærke: Electro Harmonix
Kategori: Ikke kategoriseret
Model: The Worm

Har du brug for hjælp?

Hvis du har brug for hjælp til Electro Harmonix The Worm stil et spørgsmål nedenfor, og andre brugere vil svare dig