EXSYS EX-12000 Manual


Læs gratis den danske manual til EXSYS EX-12000 (2 sider) i kategorien Netværkskort/adapter. Denne vejledning er vurderet som hjælpsom af 33 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 17 anmeldelser. Har du et spørgsmål om EXSYS EX-12000, eller vil du spørge andre brugere om produktet?

Side 1/2
6 5
Die EX 12000 ist eine USB 3.2 (Gen2) PCI Express Karte. Sie ist mit 2 externen Ports ausge-- -
stattet, die jeweils 3A Strom zu Verfügung stellen. Die EX 12000 unterstützt die volle Leistung -
von 3A an beiden externen Ports ohne das Sie zusätzlichen Strom vom PC Netzteil benötigen. -
Sie unterstützt alle PCI Express Slots von x4 bis x16. Der serielle PCI Express Bus unterstützt - -
optimal die Leistung des schnellen ASMedia Chipsatz. Die EX 12000 gewährleistet so eine -
sichere Datenübertragung und exzellente Performance von bis zu 10Gbit pro Sekunde! Die EX-
12000 unterstützt alle USB Anschlüsse von 1.1 bis 3.2.
1
ANSCHLÜSSE
AUFBAU
Anleitun
Vers. 1.0 / 05.05.21
E 1200
Kompatibilität: PCI Express p1-x4 bis x16 -
Betriebssysteme: Windows XP/ Vista/ 7/ 8.x/ 10/ Server 20xx/ Linux
Anschlüsse: 2x USB 3.2 (Gen2) C Buchse, 1x SATA 15 Pin -
Lieferumfang: 12000, Low Profile Bügel, Treiber CD, Anleitung EX-
Zertifikate:
J1: SATA 15 pin Power
Anschluss vom PC Netzteil-
DRIVER INSTALLATION
CONNECTORS
J1:
Pin Assignment Pin Assignment Pin Assignment
1 3.3 Volt (Orange) 5 Volt (pre charge) 12 Volt (pre charge) 7 - 13 -
2 3.3 Volt (Orange) 8 5 Volt (Red) 12 Volt (Yellow) 14
3 3.3 Volt (pre charge) 9 5 Volt (Red) 12 Volt (Yellow) - 15
4 Ground (Black) Ground (Black) 10
5 Ground (Black) Reserve 11
6 Ground (Black) Ground (Black) 12
HARDWARE INSTALLATION
DRIVER INSTALLATION
Windows XP/ Vista/ 7/ Server 2003/ 2008/ 2012
After starting Windows is recognizes a new Start the USB (Universal Serial Bus) Controller-“.
setup.exefile which is in the ASM3142 folder (see picture):
Follow the installation instructions and complete the installation.
Windows will now install automatically you right driver for your particular operating system. After
the installation the operating system detects the card and automatically install them.
Please note the following installation instructions. Because there are large differences between the
PCs, we can give you only a general installation instructions for the EX 12000. Please refer your -
computers reference manual whenever in doubt.
1. Turn off the power to your computer and any other connected peripherals.
2. Remove the mounting screws located at the rear and/or sides panels of your Computer and
gently slide the cover off.
3. If necessary please install now the external power supply to the card (see at Connectors at
J1).
4. Locate an available PCI-Express expansion slot and insert the card. Make sure that the card
is plugged in correctly.
5. Then attach the card with a screw to the rear panel of the computer.
6. Gently replace your computers cover and the mounting screws.
CHECK INSTALLED DRIVER
Open the >Device manager<. Now you should see at USB Controller- the following new entry's:
If you see this or a similar information the device is installed correctly.
Windows 8.x/ 10/ Server 2012 R2/ 2016/ 2019
After the hardware installation, the operating system will recognize the device automatically and
install the drivers.
CHECK INSTALLED DRIVER
Open the >Device manager<. Now you should see at USB Controller- the following new entry's:
If you see this or a similar information the device is installed correctly.
Linux
After the hardware installation, the operating system will recognize the device automatically and
install the drivers.
CHECK INSTALLED DRIVER
Now you should see the following new entry:
If you see this or a similar information the device is installed correctly.
P1 & P2:
Hinweis!
Durch die doppel Belegung der Pin s, kann der USB Typ C Stecker beidseitig in die -
Buchse gesteckt werden.
P1 & P2: 2x USB 3.2 (Gen2) C Buchse-


Produkt Specifikationer

Mærke: EXSYS
Kategori: Netværkskort/adapter
Model: EX-12000
Værtsgrænseflade: PCIe
Intern: Ja
Plug and play: Ja
Output-grænseflade: USB 3.2 Gen 2 (3.1 Gen 2)
Hot-swap: Ja
Antal USB 3.2 Gen 2 (3.1 Gen 2) type-C-porte: 2

Har du brug for hjælp?

Hvis du har brug for hjælp til EXSYS EX-12000 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Netværkskort/adapter EXSYS Manualer

Netværkskort/adapter Manualer

Nyeste Netværkskort/adapter Manualer