EXSYS EX-60111 Manual


Læs nedenfor 📖 manual på dansk for EXSYS EX-60111 (2 sider) i kategorien Netværkskort/adapter. Denne guide var nyttig for 2 personer og blev bedømt med 5.0 stjerner i gennemsnit af 1.5 brugere

Side 1/2
6 5 1
BESCHREIBUNG & TECHNISCHE DATEN
AUFBAU
Anleitun
Vers. 1.0 / 02.11.22
E 6011
Die EX 60111 ist eine High Speed 2,5 Gigabit Ethernet PCI Express Karte. Sie ist mit einem - - -
externen RJ45 Anschluss ausgestattet. Die EX 60111 unterstützt alle PCI Express Slots von x1 - -
bis x16. Der serielle PCI Express Bus unterstützt optimal die Leistung des schnellen Realtek -
mance von bis zu 2,5 Gbit/s!
RJ45 Anschluss
Status LED´s
Kompatibilität: PCI Express p1-x1 bis x16 -
Betriebssysteme: Windows 98SE / ME Vista / 7 / 8.x / 10 / 11 / Server 20xx / / 2000 / XP /
Linux / Unix
Anschlüsse: 1x RJ45 2,5 Gigabit Ethernet Anschluss
Lieferumfang: 60111, Treiber CD, Low Profile Bügel, Anleitung EX-
ANSCHLÜSSE & LED`S
RJ45 Anschluss:
Status LED´s:
RJ45 Anschluss
Pin Signal Pin Signal Pin Signal
1 BI_DA+ 4 BI_DC+ 7 BI_DD+
2 BI_DA 5 BI_DC 8 BI_DD - - -
3 BI_DB+ 6 BI_DB -
DRIVER INSTALLATION
Windows
After completing the hardware installation, the operating system will automatically the card and
ROM drive (eg drive D:) and then open the folder RTL8125/Windows Please select the folder “.
with your operating system and install the driver (see Picture). Follow the hardware assistant
and finish the installation. Restart your PC in any case after installing the drivers.Important!
CHECK INSTALLED DRIVER
Open the >Device manager<. Now you should see at Networkadapterthe following new entry:
If you see this or a similar information the device is installed correctly.
HARDWARE INSTALLATION
Please note the following installation instructions. Because there are large differences between the
PCs, we can give you only a general installation instructions for the EX-60111. Please refer your
computer s reference manual whenever in doubt.
1. Turn off the power to your computer and any other connected peripherals.
2. Remove the mounting screws located at the rear and/or sides panels of your Computer and
gently slide the cover off.
3. Locate an available PCI-Express expansion slot and insert the card. Make sure that the card
is plugged in correctly.
4. Then attach the card with a screw to the rear panel of the computer.
5. Gently replace your computers cover and the mounting screws.
DRIVER INSTALLATION
Linux / Unix
After completing the hardware installation, the operating system will automatically the card and
ROM drive (eg drive D:) and then open the folder RTL8125/Linux Please select the folder with “.
your operating system and install the driver (see Picture). Follow the hardware assistant and
finish the installation. Restart your PC in any case after installing the drivers.Important!
ACT LAN DATA LINK / Connected
Switzerland:
EXSYS Vertriebs GmbH
Dübendorfstrasse 17
8602 Wangen
www.exsys.ch
Germany:
EXSYS Vertriebs GmbH
Industriestrasse 8
61449 Steinbach
www.exsys.de
Italy:
EXSYS Italia Srl
Via Belvedere, 45/B
I 22100 Como -
www.exsys.it
Schweiz:
EXSYS Vertriebs GmbH
Dübendorfstrasse 17
8602 Wangen
www.exsys.ch
Deutschland:
EXSYS Vertriebs GmbH
Industriestrasse 8
61449 Steinbach
www.exsys.de
Italia:
EXSYS Italia Srl
Via Belvedere, 45/B
I 22100 Como -
www.exsys.it
2 3
4
TREIBER INSTALLATION
Windows
Nach Abschluss der Hardwareinstallation erkennt das Betriebssystem automatisch die Karte
und installiert diese! Falls die Treiber nicht automatisch installiert werden sollten, legen Sie nun
die Treiber CD in Ihr CD ROM Laufwerk (z.B. Laufwerk D:) ein und öffnen Sie den Ordner -
“. RTL8125/Windows Nun wählen Sie den Ordner Ihres Betriebssystems aus und installieren
Sie die Treiber (siehe Abbildung). Folgen Sie den Installationsanweisungen und schließen Sie
die Installation ab. Starten Sie Ihren PC nach der Installation neu.Wichtig!
ÜBERPRÜFEN DES INSTALLIERTEN TREIBER
Öffnen Sie den . Jetzt müssten Sie unter folgenden >Geräte Manager<- Netzwerkadapter
neuen Eintrag sehen:
Ist dieser oder ein ähnlicher Eintrag vorhanden, ist die Karte richtig installiert.
LAYOUT
Manua
Vers. 1.0 / 02.11.22
E 6011
HARDWARE INSTALLATION
Beachten Sie bitte die folgenden Installationshinweise. Da es große Unterschiede zwischen PC s
gibt, können wir Ihnen nur eine generelle Anleitung zum Einbau der EX-60111 geben. Bei Unklar-
heiten halten Sie sich bitte an die Bedienungsanleitung Ihres Computersystems.
1. Schalten Sie Ihren Rechner und alle angeschlossenen Peripheriegeräte aus und ziehen Sie
bei allen Geräten den Netzstecker.
2. Lösen Sie die Schrauben des Gehäuses auf der Rückseite Ihres Computers und entfernen
Sie vorsichtig das Gehäuse.
3. Suchen Sie jetzt einen freien PCI Express Steckplatz und stecken Sie die EX- -60111 vorsich-
tig in den ausgewählten PCI Express Steckplatz ein. Beachten Sie, das die EX- -60111 korrekt
eingesteckt ist und das kein Kurzschluss entsteht.
4. Danach befestigen Sie die EX 60111 mit einer Schraube am Gehäuse. -
5. Jetzt das Computergehäuse mit den Schrauben wieder schließen.
TREIBER INSTALLATION
Linux / Unix
Nach Abschluss der Hardwareinstallation erkennt das Betriebssystem automatisch die Karte
und installiert diese! Falls die Treiber nicht automatisch installiert werden sollten, legen Sie nun
die Treiber CD in Ihr CD ROM Laufwerk (z.B. Laufwerk D:) ein und öffnen Sie den Ordner -
“. RTL8125/Linux Nun wählen Sie den Ordner Ihres Betriebssystems aus und installieren Sie
die Treiber (siehe Abbildung). Folgen Sie den Installationsanweisungen und schließen Sie die
Installation ab. Starten Sie Ihren PC nach der Installation neu.Wichtig!
DESCRIPTION & TECNICAL INFORMATION
The EX 60111 is a high speed 2.5 Gigabit Ethernet PCI Express card. It is equipped with an - - -
external RJ45 port. The EX 60111 supports all PCI Express slots from p2-x1 to x16. The serial PCI- -
-Express bus optimally supports the performance of the fast Realtek chipset. The EX 60111 -
thus ensures secure data transmission and excellent performance of up to 2.5 Gbit/s!
Compatibility: PCI Express p2-x1 to x16 -
Operating System: Windows 98SE / ME Vista / 7 / 8.x / 10 / 11 / Server 20xx / / 2000 / XP /
Linux / Unix
Connectors: 1x RJ45 2.5 Gigabit Ethernet Port
Extent of Delivery: 60111, Driver CD, Low Profile Bracket, Manual EX-
CONNECTORS & LED S
RJ45 Port:
Status LED´s:
RJ45 Port
Pin Signal Pin Signal Pin Signal
1 BI_DA+ 4 BI_DC+ 7 BI_DD+
2 BI_DA 5 BI_DC 8 BI_DD - - -
3 BI_DB+ 6 BI_DB -
ACT LAN DATA LINK / Connected
RJ45 Port
Status LED´s


Produkt Specifikationer

Mærke: EXSYS
Kategori: Netværkskort/adapter
Model: EX-60111

Har du brug for hjælp?

Hvis du har brug for hjælp til EXSYS EX-60111 stil et spørgsmål nedenfor, og andre brugere vil svare dig