Fantini Cosmi K15A Manual


Læs gratis den danske manual til Fantini Cosmi K15A (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 3 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 2 anmeldelser. Har du et spørgsmål om Fantini Cosmi K15A, eller vil du spørge andre brugere om produktet?

Side 1/4
1
K15A
SELF-ADJUSTING HEATING CABLES FOR
PIPELINES, GUTTERS, DOWNSPOUTS AND ROOFS
Suitable for protection against
the freezing of water pipes and
to prevent the formation of ice on
roofs and gutters
Optimisation of energy
consumption thanks to the self-
adjusting feature of the cable
HEATING CABLES
CODE Cable
length
Minimum
installation
room
temperature
Maximum
room
temperature
powered
Maximum
room
temperature
not powered
Maximum length
of the heating
circuit
from the
supply point
K15A25 25 m -35 °C 65 °C 80 °C 110 m
K15A50 50 m -35 °C 65 °C 80 °C 110 m
K15A75 75 m -35 °C 65 °C 80 °C 110 m
K15A100 100 m -35 °C 65 °C 80 °C 110 m
K15A500 500 m -35 °C 65 °C 80 °C 110 m
K15A1000 1000 m -35 °C 65 °C 80 °C 110 m
HOMOLOGATION AND STANDARDS
CSTB
OPERATION
The heating cables automatically vary the heat
emission without control thermostats being used;
They consist of conductors insulated by polymers,
which vary their resistance according to the
temperature which they are subjected to.
2
K15A - SELF-ADJUSTING ANTIFREEZE HEATING CABLES FOR ROOFS AND GUTTERS
Ø PIPE Minimum room temperature
with 25 mm coating
on the pipe
mm
inches -10°C -20°C
19 3/4 1:1 1:1
25 1 1:1 1:1
38 1 1/2 1:1 1:1
50 2 1:1 1:1
63 2 1/2 1:1 1.4:1
75 3 1:1 1.6:1
100 4 1:1 2:1
INSTALLATION
The cable can be cut to the desired length;
In case of installation for roof protection, the cable
must be laid with a serpentine path;
In case of installation for the protection of
downpipes and gutters, the cable must be secured
longitudinally;
In case of installation for the protection of small
pipes, the cable can be secured linearly along the
pipe with the relevant fixing tape;
For medium-large pipes, on the other hand, the
heating cable may need to be wound so as to
ensure adequate prevention against frost forming
inside the pipe;
Refer to the table below to check whether the
cables must be wound in a spiral with an increase
in the required length;
The power of a metre of cable varies with
temperature; the total power therefore, depends
on the length of the heating cable. The heating
core is active along the entire length of the cable,
therefore, a cold end must be created so as to have
a section with cold tail.
The table shows the ratio between the length of the heating cable
with that of the pipe, depending on the outside temperature and
the pipe Ø. The values shown are based on the use of an insulating
coating with a thickness of 25 mm with a coefficient of thermal
conductivity of 0.034 W/m at 0°C.


Produkt Specifikationer

Mærke: Fantini Cosmi
Kategori: Ikke kategoriseret
Model: K15A

Har du brug for hjælp?

Hvis du har brug for hjælp til Fantini Cosmi K15A stil et spørgsmål nedenfor, og andre brugere vil svare dig