Joranalogue Route 4 Manual


Læs gratis den danske manual til Joranalogue Route 4 (5 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 19 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 10 anmeldelser. Har du et spørgsmål om Joranalogue Route 4, eller vil du spørge andre brugere om produktet?

Side 1/5
ROUTE 4
LATCHING SIGNAL ROUTER
1
INTRODUC TION
Flexible Eurorack signal paths under gate or
trigger control: that is the basic principle behind
Route 4. Consisting of a pair of complementary
routing sections, it grants access to a new level of
signal routing options.
The module's top section is a 4-to-1 router. Any of
the four signal inputs may be selected to be
mixed into the section's output, as determined
by the control inputs.
Control can either be gate or latch driven—in the
latter case, the signal inputs are toggled on and
off by received trigger pulses. Meanwhile, the
solo/multi switch determines whether the inputs
are exclusive, or if multiple may be active at the
same time.
With each input socket biased by a +1 V precision
voltage source when left unused, gate or trigger
controlled transposition of pitch sequences
becomes a breeze.
On the bottom, the 1- -to 4 router provides the
same feature set, with a single input being
routed to up to four outputs and normalisation
between the sections adding some patching
convenience.
All signal paths are designed for use with any
Eurorack signals, whether they be control
voltages, audio or gate streams. Visual feedback
is provided by 10 responsive LEDs, continually
displaying the status of the routers.
With Route 4, a n 8 -HP super flexible analogue
mixing and routing powerhouse has arrived to
fuel your patching imagination. The ability to
redirect signals within a modular system on the
fly, with an unparalleled level of control, is sure to
excite even the most seasoned patcher.
CONTENTS
In the Route ’ll 4 box, you find:
Product card, stating serial number and
production batch.
16- - -to 10 pin Eurorack power cable.
Mounting hardware: two black M3 x 6 mm
hex screws, two black nylon washers and a
hex key.
T 4 he Route module itself, in a protective
cotton bag.
If any of these items are missing, please contact
your dealer or support@joranalogue.com.
ROUTE 4
LATCHING SIGNAL ROUTER
2
CONTROLS & CONNECTIONS
1 GATE/LATCH SWITCH
The Routegate/latch switch determines how 4
will respond to its control inputs. In gate mode,
signal routing channels are only enabled as long
as the corresponding control input is high.
When switched to latch mode, a rising edge on a
control input will toggle the state of the
corresponding routing channel between
enabled and disabled.
Each section has its own gate/latch switch,
allowing different behaviour to be selected for
the module’s top and bottom routers.
2 SOLO/MULTI SWITCH
When this switch is in solo mode, only one signal
routing channel may be active at a time. A rising
edge on any control input will disable all other
routing channels.
In this mode, applying simultaneous rising edges
to two or more inputs will trigger a global reset,
disabling all channels.
When the switch is set to multi mode, any
number of channels may be enabled
simultaneously.
Each section has its own solo/multi switch,
allowing different behaviour to be selected for
the module’s top and bottom routers.


Produkt Specifikationer

Mærke: Joranalogue
Kategori: Ikke kategoriseret
Model: Route 4

Har du brug for hjælp?

Hvis du har brug for hjælp til Joranalogue Route 4 stil et spørgsmål nedenfor, og andre brugere vil svare dig