WRS-5 Wastewater Removal System Kits
OWNER'S MANUAL
English
EN
Wastewater Removal System Kits (WRS-5) are designed to
pump wastewater from laundry trays, washing machines, sinks,
or dehumidifiers. They are not designed to pump raw sewage,
fluids other than water, or fluids with solids. An inlet screen will
remove many solids over ⅛-inch diameter, but large amounts
of solids can clog the screen and result in pump failure. See
pump manual for more information.
Maximum fluid temperature is 125 °F. The unit is designed to fit
under most sinks, so in many cases it is not necessary to recess
the unit into the floor.
This product is covered by a Limited Warranty for a period of 1
year from the date of original purchase by the consumer. For complete warranty information, refer to
www.LittleGiant.com
.
Specifications
SAFETY INSTRUCTIONS
This equipment should be installed and serviced by technically qualified personnel who are familiar with
the correct selection and use of appropriate tools, equipment, and procedures. Failure to comply with
national and local electrical and plumbing codes and within Little Giant recommendations may result in
electrical shock or fire hazard, unsatisfactory performance, or equipment failure.
Know the product’s application, limitations, and potential hazards. Read and follow instructions carefully to
avoid injury and property damage. Do not disassemble or repair unit unless described in this manual.
Failure to follow installation or operation procedures and all applicable codes may result in the following
hazards:
Model Volts HP Hz Amps Watts
Shut Off
ft (m)
WRS-5 115 1/6 60 2 380 21 (6.4)
Risk of death, personal injury, or property damage due to explosion,
fire, or electric shock.
• Do not use to pump flammable, combustible, or explosive fluids such as gasoline, fuel oil, kerosene, etc.
• Do not use in explosive atmospheres or hazardous locations as classified by the NEC, ANSI/NFPA70.
• Do not handle a pump or pump motor with wet hands or when standing on a wet or damp surface, or in water.
• When a pump is in its application, do not touch the motor, pipes, or water until the unit is unplugged or electri-
cally disconnected.
• If the power disconnect is out of sight, lock it in the open position and tag it to prevent unexpected application of
power.
• If the disconnect panel is not accessible, contact the electric company to stop service.
