
Radio Replacement and Steering Wheel Control
Interface for Select Nissan Vehicles
© 2022 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
Introduction and Features
1. These instructions apply to R.1.5.1.4 or later revisions. The revision info can be found on a small white sticker on the interface
2. The radio select rotary switch on the side of the interface, must be adjusted to the proper radio setting before plugging the
interface into the vehicle (see next page for setting chart).
3. The interface comes pre-programmed for all of the vehicle’s factory SWC functions, and does not require programming unless
you wish to re-assign the SWC functions, or utilize short press, long press dual command functionality. The SWC can always
be restored to default settings by pressing and releasing the program button on the side of the interface once, and waiting 7
seconds for the LED to ash 4 times.
4. Does not retain 360 camera system.
The RP4-NI13 interface allows the replacement of a factory radio in select Nissan vehicles with MSCAN databus radios.
Using this interface will retain factory features, such as steering wheel controls (SWC), reverse camera, and the factory
amplier, when the original radio is removed. Use of this interface also allows you to program two radio functions to
each SWC button by using short press, long press dual command functionality. The RP4-NI13 also provides outputs
such as vehicle speed sensor (VSS), illumination and *reverse trigger.
Blue / White Amp Turn On Input
Orange / White Illumination Output
Purple / White *Reverse Output (+)
White / Black Front L - input
Gray / Black Front R - input
Green / Black Rear L - input
Purple / Black Rear R - input
Yellow RCA *Reverse Camera
* Only available in vehicles equipped with a factory reverse camera.
Aftermarket Radio Connections
See above chart for wire color