PAC SWI-X Manual


Læs gratis den danske manual til PAC SWI-X (8 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 2 personer og har en gennemsnitlig bedømmelse på 3.5 stjerner ud af 1.5 anmeldelser. Har du et spørgsmål om PAC SWI-X, eller vil du spørge andre brugere om produktet?

Side 1/8
1
06-14-07
SWI-X Universal Steering Wheel Control Interface
Installation Instructions
Before You Start
A. Is this product compatible with the vehicle?
• See application guide (seperate sheet) for listing of vehicles and connection information. If not, check www.pac-
audio.com for an updated list of compatible vehicles.
B. Is this product compatible with the head unit?
remote control provided with it.
• The head unit must accept a remote control with the common carrier frequency range of 38 – 40Khz in order to
work with the SWI-X.
Note: Appendix B - Known Incompatible Aftermarket Head Certain head units will not work with the SWI-X. See
Units (page 7).
C. Prepare for the installation.
• If possible, install the SWI-X while you are installing the new head unit. Keep in mind you may need to plug in the
factory stereo to locate certain wires; therefore do not complete the head unit installation until the SWI-X is working
properly.
• Plan a general installation location for both the SWI-X LED and the control body. Keep in mind that the supplied
wire harness is , and the IR harness is .two feet long four feet long
• Use a multimeter or approved measuring device for checking vehicle circuits.
Pacific Accessory Corporatio
n
SEEK
PRESET
AM FM
VOLUME
PLAY
MUTE
0OWER
SWI-X is a learning remote.
37)8
Steering wheel
audio control wire
Aftermarket stereo must come with
a wireless remote.
2
Wiring Connections
Step 1.
Connect the BLACK
wire to ground (-).
9HUL¿FDWLRQ Wire
or location registers
a constant (-) when
probed.
Step 2.
Connect the RED wire
to switched +12V.
9HUL¿FDWLRQ Wire reg-
isters +12V when the
ignition key is turned
to the ACC or ON posi-
tions.
Step 3.
Connect the appropriate interface wire (WHITE, YELLOW, ORANGE or
GREEN).
• Refer to the . Locate the vehicle and ,GHQWL¿FDWLRQDQG&RQQHFWLRQ&KDUW
note the SWC wire color in the “Interface Wire Color” column.
1RWHWKHYHKLFOHZLUHFRORUDQGORFDWLRQLQIRUPDWLRQLQWKH³,GHQWL¿FDWLRQ´
column.
Note: You will only connect ONE of these wires. The other 3 wires will not
be used. Cut and insulate the unused wires.
• Connect the wire as indicated in the chart.
Note: Only 3 wires will be used during installation. Only GM vehicles programmed for version #4, will use 4 wires.
Step 4a.
Connect the BLUE
serial data wire.
Connect this wire
ONLY on GM
passenger vehicles (no
trucks or SUVs) with
airbags AND steering
wheel heater controls.
For all other vehicles,
cut and insulate the
BLUE wire.
Step 4b.
If instructed by the
Vehicle Application
Guide, cut the
BROWN wire loop and
insulate both halves.
Step 4c.
If instructed by the
Vehicle Application
Guide, cut the VIOLET
wire loop and insulate
both halves, or place a
resistor in-line of wires.
Note: is for vehicles made by Step 4a
General Motors that are programmed
for version #4 only. If no connections is
necessary, proceed to Step 4b.
Step 4
If necessary, perform the following operations as indicated by the notes in .,GHQWL¿FDWLRQDQG&RQQHFWLRQ&KDUW


Produkt Specifikationer

Mærke: PAC
Kategori: Ikke kategoriseret
Model: SWI-X

Har du brug for hjælp?

Hvis du har brug for hjælp til PAC SWI-X stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret PAC Manualer

PAC

PAC CAM-GM51 Manual

11 Juli 2025
PAC

PAC TY1A-RS Manual

11 Juli 2025
PAC

PAC SR-F15009HX Manual

10 Juli 2025
PAC

PAC SRK-RAM13HX Manual

10 Juli 2025
PAC

PAC AAI-TY3 Manual

30 Juni 2025
PAC

PAC SRK-GM14HX Manual

10 Marts 2025
PAC

PAC C2A-CHY Manual

19 Februar 2025
PAC

PAC SWI-X Manual

19 Februar 2025
PAC

PAC NU-GM4 Manual

19 Februar 2025
PAC

PAC OnStar OS-311b Manual

17 Februar 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer