Panduit FPONE3 Manual

Panduit Ikke kategoriseret FPONE3

Læs gratis den danske manual til Panduit FPONE3 (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 11 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 6 anmeldelser. Har du et spørgsmål om Panduit FPONE3, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

For Technical Support: www.panduit.com/resources/install_maintain.asp

INSTALLATION INSTRUCTIONS

Page 1 of 2

Fiber PON Enclosure

Part Number(s): FPONE3

Bottom

Front

Back

SPECIFICATIONS:

Material: SMC, water resistant, dust-proof, IP55

Dimension (HxWxD): 400 x 300 x 110 mm

Color: Light Gray

Adapter Type: SC

Number of Adapters: Max 32

Number of Splitters: Max 1 (N x 2, N x 4, N x 8, and N x 16,) and Max 1(N x 32)

Single Fusion Capacity: Max 32

The fiber radius of curvature is over 40 mm.

Wall Mount

Drop Cable Exit

OSP Cable Entry

Adapter Storage

Product Structure and Cable Entry

E-mail:

techsupport@panduit.com

Phone:

866-405-6654

For Instructions in Local Languages

and Technical Support:

www.panduit.com/resources/install_maintain.asp

INSTALLATION INSTRUCTIONS

www.panduit.com

Page 2 of 2

Enclosure Installation and drop cable attachment

1. FInd the mounting screws and hardware included in the product packaging.

2. Drill holes as needed and use expansion hardware as needed. Use the mounting screws to fasten the enclosure

to the wall.

3. Route the drop cables through the attachment hardware on the bottom right hand side of the base. Then route

the drop cables around the base of the enclosure so that they enter onto the front of the flip tray.

4. Attach the connectorized end into the adapters. Match the adapter number with the appropriate cable number.

Pigtail Installation

Pigtails with connectors on one end should have connectorized end attached to the adapter located in the adapter

storage. The pigtail fiber ends will need to be routed to the to the splice storage panel and prepared for splicing.

Splitter Installation

5. Splitters are available with connectorized or with bare fibers. If the splitter is connectorized, then attach the

connectors to the adapter located in the adapter storage. from the breakout side first, one at a time.

6. Then attach the splitter on the rear of the flip tray.

Outside Plant Cable Installation

7. The outside plant cable is routed into the bottom left hand corner of the base and attached inside the bracket at

the base of the enclosure.

8. The cable is to be prepped with 38 inches of exposed unit tube that is routed in the base of the enclosure and

routed to the fiber storage around the splice storage.

9. The unit tube that will be spliced is to be prepped by stripping to expose 18 inches of the fiber that will be

spliced to the pigtail.

10. Once the fusion splice is completed cover with the splice sleeve, it should be installed in the splice storage,

and then the fiber slack is routed around the fiber storage.

Produkt Specifikationer

Mærke:	Panduit
Kategori:	Ikke kategoriseret
Model:	FPONE3
Kode for international beskyttelse (IP):	IP68
Bredde:	420 mm
Dybde:	110 mm
Højde:	350 mm
Produktfarve:	Hvid