CRUX RVCCH-75CC Manual

CRUX Bakkamera RVCCH-75CC

Læs gratis den danske manual til CRUX RVCCH-75CC (3 sider) i kategorien Bakkamera. Denne vejledning er vurderet som hjælpsom af 46 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 23.5 anmeldelser. Har du et spørgsmål om CRUX RVCCH-75CC, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/3

RVCCH-75C

Rear View Integration Interface with VIM

for CHRYSLER, DODGE & JEEP

INTERFACING SOLUTIONS

Sightline

Multi View Integration

Crux Interfacing Solutions • 6860 Canby Ave., Suite 104, Reseda, CA 91335

phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com

rev.010319

1 of 3

• Acvates Uconnect Touchscreen Radio for enabling Video features

• Aermarket Rear-view Camera included

• Automacally switches to Rear-view when car is in Reverse mode

• Forced reverse camera view feature

• VIM funcon

• Plug & Play Installaon

PRODUCT FEATURES:

PARTS INCLUDED:

RVCCH-75C Module RVCCH-75C Harness CCH-01G Camera

INSTALLATION DIAGRAM:

WHITE Wire

Parking Guideline

To Radio

OEM Radio

Harness

DIP

SWITCH

LED*

*LED RED = Power ON Status

LED BLUE = Data Bus ON Status

RVC Video

Signal Input

RED Wire Push in Connectors

all the way

Line up Arrows

Regulator

20 Ft. Coax Cable

RED Wire

Tape O

(Not Used)

BLACK

Wire

BLACK

(Ground)

8-Pin Molex Represents Solder Joint

Connect RCAs and secure

with tape all around

WHITE Wire

(Camera Power Output

+12V 250mA)

OR*

*Connect BLACK (ground) wire to chassis ground.

If video noise is present, we recommend connecting the

ground wire to the BLACK ground wire on the RVCCH-75C harness.

Chassis Ground

GREEN Wire

For Non Permanent

VIM function

Crux Interfacing Solutions • 6860 Canby Ave., Suite 104, Reseda, CA 91335

phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com

rev.010319

2 of 3

INTERFACING SOLUTIONS

Sightline

Multi View Integration

DIP SWITCH SETTINGS:

INSTALLATION INSTRUCTIONS:

INSTALLING THE CDR-02 CAMERA AND CABLE

1. Remove the rear panel lip.

2. Drill a 5/8 inch size hole in the available locaon.

3. Fish the wires thought the drilled hole and through the pass through into the trunk/cargo area.

4. Route the wires towards the radio and make the power and video connecons. For powering up the camera, use the 12V

OUTPUT (White Wire). (See Wiring Diagram on page 1)

5. Connect the camera ground wire to chassis ground. If video noise is present, we recommend grounding the camera

directly to the BLACK wire on the RVCCH-75C T-harness.

6. Test the camera before re-installing the radio.

CODING THE RADIO FOR A REAR VIEW CAMERA

The radio has to be coded to accept a reverse camera. Please follow the coding procedure below:

1) Turn key o and remove the key from ignion.

2) Open the driver door then close it (make sure all doors, li gate and hood are also closed).

3) Look at the module and wait for LEDs to turn o then disconnect the module.

4) Before plugging back the module, turn all DIP switches to ON then OFF.

5) Set DIP switches 1 (if permanent VIM is desired), 2 and 6 to the ON posion.

6) Reconnect module and wait for the LEDs to turn o.

7) Start up engine and the coding operaon is complete.

8) Put the gear in reverse to test the camera.

FORCED VIEW OF REVERSE CAMERA

The Force RVC is used to view the back-up camera when the vehicle is

not in reverse gear. Allows you to view what is in the back while driving.

To acvate this feature, make sure that DIP 4 is set to ON. Press the center

buon once on the le hand side steering wheel control (located behind the steering wheel).

NOTE: The camera is defaulted to power down aer 10 seconds.

DIP SWITCH FUNCTIONS:

DIP 1 = Video in Moon Acvaon ON / OFF

DIP 2 = Rear View Camera ON / OFF

DIP 3 = Not Used

DIP 4 = Forced RVC ON / OFF

DIP 5 = Defaulted to OFF*

DIP 6 = Defaulted to ON*

RVCCH-75C

Rear View Integration Interface with VIM

for CHRYSLER, DODGE & JEEP

*DIP 5 & 6

If the radio is having turn-on issues, please try the following:

Aempt 1: Set 5 & 6 to ON

Aempt 2: Set 5 to ON and 6 to OFF

Aempt 3: Set 5 to OFF and 6 to ON

1 2 3 4 5 6

Produkt Specifikationer

Mærke:	CRUX
Kategori:	Bakkamera
Model:	RVCCH-75CC

Har du brug for hjælp?

Hvis du har brug for hjælp til CRUX RVCCH-75CC stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Bakkamera CRUX Manualer

24 Juli 2025

29 December 2024

29 December 2024

29 December 2024

29 December 2024

CRUX RVCCH-75RC Manual

18 November 2024

CRUX RVCCH-75DC Manual

16 August 2024

CRUX RVCCH-75WTC Manual

15 August 2024

CRUX CNS-03V Manual

15 August 2024

CRUX CVW-07G Manual

15 August 2024

Bakkamera Manualer

Nyeste Bakkamera Manualer

Pyle PLCMTR72 Manual

8 August 2025

Pyle PLCM4590WIR Manual

8 August 2025

Pyle PLCMTR78WIR Manual

8 August 2025

Biltema 43-170 Manual

25 Juli 2025

Rockville RBC-1 Manual

22 Juli 2025

Rockville RBC-5 Manual

22 Juli 2025

Dometic PerfectView CAM 12 Manual

21 Juli 2025

Rockville RBC4 Manual

16 Juli 2025

Rockville RBC2 Manual

16 Juli 2025

Rockville RBC3 Manual

16 Juli 2025