Elektrobock Pocket Home PH-SP2 Manual

Elektrobock Modtager Pocket Home PH-SP2

Læs gratis den danske manual til Elektrobock Pocket Home PH-SP2 (4 sider) i kategorien Modtager. Denne vejledning er vurderet som hjælpsom af 49 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 25 anmeldelser. Har du et spørgsmål om Elektrobock Pocket Home PH-SP2, eller vil du spørge andre brugere om produktet?

Side 1/4
Version 11.02
Wireless receiver for control of
electric heating devices
- WALL-MOUNTED -
PH-SP2
Operating instructions
Control of electric heating systems
Component of the PocketHome
®system
Two-way radio communication at 433,92 MHz
The connected electric appliance is switched according to
the required temperature
The control unit PH-BSP is the pilot component
The device can only be installed by a person with adequate qualification!
The installation must be executed in a voltage-free state!
holes for
installation
on KU/KP68
Fig.1 Fig.2 Fig.3
230 V/ 50 Hz
Wiring diagram:
L
N
FUNCTION BUTTON:
SHORT PRESSING - coding.
LONG PRESSING (for about 5 s) - RESET
deleting the code from the memory (the green and
red LEDs flash simultaneously).
max.
16 A
Fig.4
INSTALLATION
output terminals
power supply
terminals
FUNCTION
BUTTON
PH-SP2 is used for switching the heating device in connection
with the PH-BSP control unit.


Produkt Specifikationer

Mærke: Elektrobock
Kategori: Modtager
Model: Pocket Home PH-SP2

Har du brug for hjælp?

Hvis du har brug for hjælp til Elektrobock Pocket Home PH-SP2 stil et spørgsmål nedenfor, og andre brugere vil svare dig