Mikrotik LtAP Manual


Læs gratis den danske manual til Mikrotik LtAP (9 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 32 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 16.5 anmeldelser. Har du et spørgsmål om Mikrotik LtAP, eller vil du spørge andre brugere om produktet?

Side 1/9
LtAP
LtAP
LtAP
LtAPLtAP
LtAP
The LtAP is a wireless access point with three SIM card slots for cellular data modems.
Safety Warnings
Before you work on any equipment, be aware of the hazards involved with electrical circuitry, and be familiar with standard practices for preventing
accidents.
Read the installation instructions before connecting the system to the power source.
This equipment is to be installed by trained and qualified personnel, as per these installation instructions. The installer is responsible for obtaining any
required local or national safety inspections of the structural integrity of the installation by the local authority/inspection department.
All installation methods for mounting an access point on any wall surface is subject to the acceptance of local jurisdiction.
The Installation of the equipment must comply with local and national electrical codes.
This product is intended to be mounted outdoors on a pole but can also be installed indoors. Please read the mounting instructions carefully before
beginning installation. Failure to use the correct hardware and configuration or to follow the correct procedures could result in a hazardous situation to
people and damage to the system.
We cannot guarantee that no accidents or damage will occur due to the improper use of the device. Please use this product with care and operate at your
own risk.
Exposure to Radio Frequency Radiation:
Exposure to Radio Frequency Radiation:
Exposure to Radio Frequency Radiation:
Exposure to Radio Frequency Radiation:Exposure to Radio Frequency Radiation:This MikroTik equipment complies with the FCC, IC, and European Union radiation exposure limits set forth for an
uncontrolled environment.This MikroTik device should be installed and operated no closer than 120 centimeters from your body, occupational user, or the
general public.
Quickstart
Please follow these quick steps to set up your device:
Unscrew two screws and remove doors to access all ports. Please see the section.Mounting
Connect your Internet cable to the Ethernet port (this is optional if using LTE as the primary connection).
Install your modem see slot usage (optional).miniPCIe
Insert the SIM card into the slot (optional) (see ).SIM card
Connect GPS antenna (optional).
Mount unit in your desired place, please see paragraph.Mounting
Choose your powering solution, please see the section for possibilities.Powering
Download the WinBox configuration tool ;https://mt.lv/winbox
There is no default IP address set, user name: and there is no password (or, for some models, check user and wireless passwords on the
admin
sticker), usetheNeighborstab and connect through the MAC address;
We recommend clicking the "Check for updates" button and updating your RouterOS software to the latest version to ensure the best
performance and stability.
Choose your country, to apply country regulation settings, and set up your password on the screen that loads.
Set the to indoors or outdoors, depending on the usage type.
Installation
*The following RouterOS "npk" packages are required for the core functionality of the product: gps, system.
Extension slots and ports
1.
2.
3.
4.
Built-in 2 GHz wireless access point module, AP/station/bridge/p2p modes are supported. Onboard PIF antennas built-in, as well as MMCX
connectors for external antennas (software selectable).
Two miniPCIe slots and three SIM slots.
Built-in GPS module with an external SMA connector. Supports -GPS, GLONASS, BeiDou, Galileo).
Gigabit Ethernet port, supporting automatic cross/straight cable correction (Auto MDI/X). Either straight or crossover cable can be used for
connecting to other network devices. The Ethernet port accepts 12-30 V DC powering from a passive PoE injector.
One DB9 RS232 serial port for serial console access. Configured as 115200 bit/s, 8 data bits, 1 stop bit, no parity.
One USB 2.0 port for storage devices or cellular modems.
Mounting
It is possible to attach the device to a wall, using the provided four screws and designed four holes on the unit.
The ports are protected with a small door, that is held in place with two screws. Remove to access Ethernet ports, antenna connector, SIM slots,
etc.
The door has cut-out places for all available ports, so you can guide through all necessary cables, but please only break out the openings that you
will use.
Several places for external antennas are provided on the case, use an appropriate size drill, to make them available. Be careful and measure the
chosen antenna, so that it does not touch the internal PCB board when installed.


Produkt Specifikationer

Mærke: Mikrotik
Kategori: Ikke kategoriseret
Model: LtAP

Har du brug for hjælp?

Hvis du har brug for hjælp til Mikrotik LtAP stil et spørgsmål nedenfor, og andre brugere vil svare dig