PAC C2R-CHYNA Manual

PAC Ikke kategoriseret C2R-CHYNA

Læs gratis den danske manual til PAC C2R-CHYNA (1 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 12 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 6.5 anmeldelser. Har du et spørgsmål om PAC C2R-CHYNA, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

Pacic Accessory Corporation 1502 S. Santa Fe St. Santa Ana, CA 92705

Voice: 714-835-3022 • Fax: 714-835-3233

www.pac-audio.com

10-12-06

DISCLAIMER: Under no circumstances shall the manufacturer or the distributors of the C2R-CHYNA parts be held liable for consequential

damages sustained in connection with the C2R-CHYNA. The manufacturer and it’s distributors will not, nor will they authorize any

representative or any other individual to assume obligation or liability in relation to the C2R-CHYNA other than its replacement.

Installation:

1. Only for Vehicles Without a Factory Amplifier: Connect the aftermarket radio’s front and rear speaker wires to the 22 pin plug.

2. The 22 pin harness has two yellow and two black wires. Connect both yellows to the radio’s +12v constant wire and both blacks

to the radio’s ground wire.

3. The Accessory wire is located on the 6 pin harness - connect this wire to the radio’s accessory wire. The accessory wire supplies

+12v, 1 amp max, when key is in the Accessory or Ignition position.

4. 11 pin plug: Orange/White - Connect this wire to the radio’s Illumination input wire only.

Note: Do not connect these wires to any other circuit besides the radio’s wire harness.

5. When all connections are made, connect the 22 pin plug into the vehicle’s 22 pin harness.

0111

1 amp

fuse holder

1#2#

tuptuO yrosseccA

.xam pma1 stlov21+

22 pin

Chrysler R

6 pin

Orange/White = Illumination

Yellow x 2 = +12v Constant

Black x 2 = ground

Gray = Right Front (+)

Gray/Black = Right Front (-)

White = Left Front (+)

White/Black = Left Front (-)

Violet = Right Rear (+)

Violet/Black = Right Rear (-)

Green = Left Rear (+)

Green/Black = Left Rear (-)

Red = +12v Accessory output

To optional SWI-CAN interface for retaining steering wheel audio controls

11 pin

C2R-CHYNA

Radio Replacement interface for 2004+

Chrysler, Dodge and Jeep vehicles

with Factory Radio Models REF, REC, RAQ and RAK.

23456

For Use with Aftermarket Radios to Retain Accessory Power

• Retains Accessory Power for Approximately 10 Minutes or Until A Door is Open

Produkt Specifikationer

Mærke:	PAC
Kategori:	Ikke kategoriseret
Model:	C2R-CHYNA

Har du brug for hjælp?

Hvis du har brug for hjælp til PAC C2R-CHYNA stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret PAC Manualer

PAC CAM-GM51 Manual

11 Juli 2025

PAC TY1A-RS Manual

11 Juli 2025

PAC SR-F15009HX Manual

10 Juli 2025

PAC SRK-RAM13HX Manual

10 Juli 2025

PAC AAI-TY3 Manual

30 Juni 2025

PAC SRK-GM14HX Manual

10 Marts 2025

19 Februar 2025

19 Februar 2025

19 Februar 2025

19 Februar 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Waterstone 7800 Manual

11 December 2025

Kwikset 258 Manual

11 December 2025

Schlage F170 Manual

11 December 2025

Moen Align 7565EV Manual

11 December 2025

Energy Sistem ESG M3 Neon Manual

11 December 2025

ALNO MC10244 Manual

11 December 2025

JET TAK-ZX Manual

11 December 2025

Crosley Nashville CF1165 Manual

11 December 2025

Waterstone 1455 Manual

11 December 2025

Laica NE2015 Manual

11 December 2025