PAC OnStar OS-3 Manual

PAC Ikke kategoriseret OnStar OS-3

Læs gratis den danske manual til PAC OnStar OS-3 (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 14 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 7.5 anmeldelser. Har du et spørgsmål om PAC OnStar OS-3, eller vil du spørge andre brugere om produktet?

Side 1/2
Pacifi c Accessory Corporation - 1502 S. Santa Fe Street, Santa Ana, CA 92705
techsupport@pac-audio.com • Voice: 714-835-3022 • Fax: 714-835-3233 • www.pac-audio.com Page 1
10-15-07
The OS-3 is a plug and play interface that allows replacement of a General Motors GMLAN factory radio. It will maintain
operation of the OnStar® system. The OS-3 has on board switching and audio amplifi ers which allow audio from the
OnStar® system to play through the two front factory speakers when OnStar® is active. This interface retains all warning
chimes, the audible turn signal indicators, rear seat radio control buttons (when optional SWI interface is used) and the
Vehicle Rear Parking Assist System (if equipped).
Step 1- Pre wire the OS-3RAD wire harness to the aftermarket stereo wire harness.
Step 2- After connecting the OS-3RAD and OS-GM14 wire harness to the OS-3 main interface, connect the OS-GM14 connector to the
factory harness.
The Following General Motors Vehicles using the GMLAN Data Bus WITHOUT a Bose® Amplifi er.
Pontiac: Torrent (2007)
Saturn: Outlook (2007)
GMC: Acadia (2007) Yukon Denali (2007) Yukon (2007) Sierra - not classic (2007) Sierra Denali - not classic (2007)
Cadillac: Escalade - including ESV and EXT (2007) SRX (2007) DTS (2007)
Buick: Lucerne (2006-2007)
Chevrolet: Suburban (2007) Tahoe (2007) Avalanche (2007) Monte Carlo (2006-2007) Silverado - not classic (2007) Impala (2006-2007)
Equinox (2007)
1. The OS-3 does not retain the factory XM receiver. You will lose the XM option when the factory radio is replaced with an aftermarket
radio.
2. If you are not retaining the OnStar® system, use the C2R-GM29 instead of this OS-3 interface.
3. Built in Smart Mute Circuitry will play OnStar® audio through the front speakers while muting the radio or turning the radio off if a mute
input circuit is not present
• OnStar® active LED and Ignition on LED.
• Provides +12v switched accessory output. No more searching for switched +12v in fuse box or kick panel.
• Steering wheel radio controls can be retained to control the new radio by using the SWI - X, JACK, ECL2 or PS.
• New radio will operate with the vehicle RAP (Retained Accessory Power) circuit. The radio stays on after the key is turned off and stays on
for approximately 10 minutes or until the drivers door is opened.
Note: Connect the Purple/White wire (pin 18) from the OS-3RAD to the radios mute input. If a mute input is not available, connect the
Purple/White wire (pin 18) to the Red/White wire (pin 16) of the OS-3RAD connector. The Lt. Green wire is a SWC output wire. Do not con-
nect this wire to anything other than the green interface wire of a SWI - X, JACK, ECL, or PS. Program the SWC interface for version #2 and
DO NOT CUT the Brown SWI interface loop. When pushing the steering wheel buttons during programming, a simple press and release
of the button will do just fi ne, no need to hold. The rear controls (if equipped) will perform the same functions as the steering wheel buttons
without any additional programming necessary. If steering wheel controls are not retained or present, isolate this wire and do not use!
Wire locations and Description
WIRE COLOR CIRCUIT CIRCUIT WIRE COLOR
9 18
8 17
7 16
6 15
5 14
4 13
3 12
2 11
1 10
PIN NUMBER
SWC Output
Chime Module
White/Black
Grey/Black
Green/Black
Purple/Black
Black
Lt. Green
Orange
Blue/White
Red
Left Front(-)
Right Front (-)
Left Rear (-)
Right Rear(-)
Ground
Illumination
Amp Turn On
+12v Accessory Output
Left Front (+)
Right Front (+)
Left Rear (+)
Chime Module
Right Rear (+)
+12v Constant
White
Grey
To CM - X
Green
To CM - X
Purple
Yellow
Purple/White
Red/White
Mute Sense
Mute Output
WIRE COLOR CIRCUIT CIRCUIT WIRE COLOR
Orange Illumination
8 16
Purple/White GMLan
7 15
+12v Constant Yellow
Black Ground
6 14
Amplifier Turn On Blue
Purple/Black Right Rear (-)
5 13
Right Rear (+) Purple
Green/Black Left Rear (-)
4 12
Left Rear (+) Green
OnStar Mono(-)
3 11
OnStar Mono(+)
Grey/Black Right Front (-)
2 10
Right Front (+) Grey
White/Black Left Front (-)
1 9
Left Front (+) White
PIN NUMBER
Purple/WhiteWhite/Brown
Amp Control Black
OS-3RAD
OS-GM14
Notes
Supported Vehicles
Installation
1
1
0 0
0
0
0
0
1
1
1
0
0
1
1
1 0
0
0
0
0 0
0
1
1
0
0
1
0
0
0
1
0
1
0 0
0 0
1
0
1 0
1
0 0
1
C
l
C
a
1
0
OS-3
General Motors OnStar®
Interface Installation Instructions
for GMLAN Vehicles Without Bose®


Produkt Specifikationer

Mærke: PAC
Kategori: Ikke kategoriseret
Model: OnStar OS-3

Har du brug for hjælp?

Hvis du har brug for hjælp til PAC OnStar OS-3 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret PAC Manualer

PAC

PAC CAM-GM51 Manual

11 Juli 2025
PAC

PAC TY1A-RS Manual

11 Juli 2025
PAC

PAC SR-F15009HX Manual

10 Juli 2025
PAC

PAC SRK-RAM13HX Manual

10 Juli 2025
PAC

PAC AAI-TY3 Manual

30 Juni 2025
PAC

PAC SRK-GM14HX Manual

10 Marts 2025
PAC

PAC C2A-CHY Manual

19 Februar 2025
PAC

PAC MCI-FD22 Manual

19 Februar 2025
PAC

PAC GM6A-RST Manual

19 Februar 2025
PAC

PAC SWI-X Manual

19 Februar 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer