PAC OnStar OS-311 Manual

PAC Ikke kategoriseret OnStar OS-311

Læs gratis den danske manual til PAC OnStar OS-311 (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 52 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 26.5 anmeldelser. Har du et spørgsmål om PAC OnStar OS-311, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/2
Pacic Accessory Corporation - 1502 S. Santa Fe Street, Santa Ana, CA 92705
techsupport@pac-audio.com • Voice: 714-835-3022 • Fax: 714-835-3233 • www.pac-audio.com Page 1
04-27-07
The OS-311 is a plug and play interface that allows replacement of a General Motors GMLAN factory radio. It will maintain
operation of the OnStar® system. The OS-311 has on board switching and audio ampliers which allow audio from the
OnStar® system to play through the two front factory speakers when OnStar® is active. This interface retains all warning
chimes, the audible turn signal indicators, and provides a 12v R.A.P. (Retained Accessory Power) output circuit.
Step 1- Pre wire the OS-3RAD wire harness to the aftermarket stereo wire harness.
Step 2- After connecting the OS-3RAD and OS-LAN11 wire harness to the OS-311 main interface, connect the OS-LAN11 connector to the
factory harness.
The Following General Motors Vehicles using the GMLAN 11bit Data Bus with or without a Factory Amplier.
Pontiac: G5 (2007) Solstice (2006-2007)
Saturn: Aura (2007) Sky (2007)
Chevrolet: Cobalt (2007) HHR (2006-2007)
1. The OS-311 does not retain the factory XM receiver. You will lose the XM option when the factory radio is replaced with an aftermarket
radio.
2. If you are not retaining the OnStar® system, use the C2R-GM11 instead of this OS-311 interface.
3. Built in Smart Mute Circuitry will play OnStar® audio through the front speakers while muting the radio or turning the radio off if a mute
input circuit is not present
• OnStar® active LED and Ignition on LED.
• Provides +12v switched accessory output. No more searching for switched +12v in fuse box or kick panel.
• Steering wheel radio controls can be retained to control the new radio by using the SWI - X, JACK, ECL or PS.
• New radio will operate with the vehicle RAP (Retained Accessory Power) circuit. The radio stays on after the key is turned off and stays on
for approximately 10 minutes or until the drivers door is opened.
Note: Connect the Purple/White wire (pin 18) from the OS-3RAD to the radios mute input. If a mute input is not available, connect the
Purple/White wire (pin 18) to the Red/White wire (pin 16) of the OS-3RAD connector.
The Lt. Green wire is a SWC output. Connect this wire to a SWI - X, JACK, ECL, or PS green interface wire. The interface will need to be
programmed for version 1. Do not cut the brown loop. Use the Step by Step programming instructions included with the SWI interface.
Wire locations and Description
WIRE COLOR CIRCUIT CIRCUIT WIRE COLOR
9 18
8 17
7 16
6 15
5 14
4 13
3 12
2 11
1 10
PIN NUMBER
N/A
Chime Module
White/Black
Grey/Black
Green/Black
Purple/Black
Black
N/A
Orange
Blue/White
Red
Left Front(-)
Right Front (-)
Left Rear (-)
Right Rear(-)
Ground
Illumination
Amp Turn On
+12v Accessory Output
Left Front (+)
Right Front (+)
Left Rear (+)
Chime Module
Right Rear (+)
+12v Constant
White
Grey
To CM - X
Green
To CM - X
Purple
Yellow
Purple/White
Red/White
Mute Sense
Mute Output
WIRE COLOR CIRCUIT CIRCUIT WIRE COLOR
Orange Illumination
8 16
Purple/White GMLAN
7 15
+12v Constant Yellow
Black Ground
6 14
Amplifier Turn On Blue/White
Purple/Black Right Rear (-)
5 13
Right Rear (+) Purple
Green/Black Left Rear (-)
4 12
Left Rear (+) Green
OnStar Mono(-)
3 11
OnStar Mono(+)
Grey/Black Right Front (-)
2 10
Right Front (+) Grey
White/Black Left Front (-)
1 9
Left Front (+) White
PIN NUMBER
White/PurpleWhite/Brown
Amp Control Black/White
OS-3RAD
OS-LAN11
Notes
Supported Vehicles
Installation
OS-311
General Motors OnStar®
Interface Installation Instructions
For GMLAN 11bit Vehicles
Pacic Accessory Corporation - 1502 S. Santa Fe Street, Santa Ana, CA 92705
techsupport@pac-audio.com • Voice: 714-835-3022 • Fax: 714-835-3233 • www.pac-audio.com Page 2
04-27-07
Step 3- The CM-X should be plugged into the white 2-pin connector and permanently mounted. This module will retain all warning chimes
and audible turn signal indications. There is no volume adjustment for this feature so keep that in mind when choosing a mounting
location.
Step 4- The OnStar volume is controlled from the adjustment screw on the interface. Make sure this is set to the desired level before ®
mounting the interface and reassembling the dash. The OS-3RAD speaker inputs will not be used
Note - This conguration is used when aftermarket amplier(s) are installed to power new or existing speakers.
Step 3- The CM-X should be plugged into the white 2-pin connector and permanently mounted. This module will retain all warning chimes
and audible turn signal indications. There is no volume adjustment for this feature so keep that in mind when choosing a mounting
location.
Step 4- The OnStar volume is controlled from the adjustment screw on the interface. Make sure this is set to the desired level before ®
mounting the interface and reassembling the dash.
102.7 FM
Aftermarket stereo
30
8586
87
87a
Red wire to accessory
input of radio
c2
c1
OS-LAN11 Harness
OnStar
Active
®
Volume
Adjust
OS - 311
General Motors GMLan OnStar Interface®
Factory Radio Replacement
Retention the OnStar Option®
Ignition
On LED
Pacific Accessory Corporation Santa Ana, Ca 92705 www.pac-audio.com
OS-3RAD
CM-X
O
Chime Module
SWC output wire
Connect to SWI - X green wire
Program for Version # 1
Red/White - Mute Sense
Purple/White - Mute Output
Connecting to the Vehicle’s Factory Speakers
Connecting to External Speakers
102.7 FM
Aftermarket stereo
30
8586
87
87a
Red wire to accessory
input of radio
c2
c1
OnStar
Active
®
Volume
Adjust
OS - 311
General Motors GMLan OnStar Interface®
Factory Radio Replacement
Retention the OnStar Option®
Ignition
On LED
OS-3RAD
(-)(+) (-)(+)
White White/Black Grey Grey/Black
High Power
Speaker Outputs
Are Not Used
Pacific Accessory Corporation Santa Ana, Ca 92705 www.pac-audio.com
CM-X
O
Chime Module
SWC output wire
Connect to SWI - X green wire
Program for Version # 1
Audio Signal
to new amp(s)
Red/White - Mute Sense
Purple/White - Mute Output
OS-LAN11 Harness
Testing and Verifying Operation
1. Turn ignition on. The red ignition On LED inside the interface will turn on and the +12v accessory wire will turn on.
2. Turn on the radio and check balancing and fading.
3. Pressing the OnStar® button will turn off the radio (or mute it depending on the connections made) and allow the OnStar® audio to be
heard in the two front speakers. The OnStar® active red LED will also turn on. When OnStar® disconnects, the radio will un-mute or turn
back on and the OnStar® LED will turn off.
4. Turn off vehicle and remove key. RAP will be active and keep the radio on for 10 minutes or until the drivers door is opened.
5. The red LED and the radio will turn off when RAP turns off or the drivers door is opened.
DISCLAIMER: Under no circumstances shall the manufacturer or the distributors of the OS-311 be held liable for consequential damages sus-
tained in connection with the OS-311. The manufacture and it’s distributors will not, nor will they authorize any representative or any other indi-
vidual to assume obligation or liability in relation to the OS-311 other than its replacement.
OnStar® is a registered trademark of OnStar® Corporation.

Produkt Specifikationer

Mærke: PAC
Kategori: Ikke kategoriseret
Model: OnStar OS-311

Har du brug for hjælp?

Hvis du har brug for hjælp til PAC OnStar OS-311 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret PAC Manualer

PAC

PAC CAM-GM51 Manual

11 Juli 2025
PAC

PAC TY1A-RS Manual

11 Juli 2025
PAC

PAC SR-F15009HX Manual

10 Juli 2025
PAC

PAC SRK-RAM13HX Manual

10 Juli 2025
PAC

PAC AAI-TY3 Manual

30 Juni 2025
PAC

PAC SRK-GM14HX Manual

10 Marts 2025
PAC

PAC C2A-CHY Manual

19 Februar 2025
PAC

PAC MCI-FD22 Manual

19 Februar 2025
PAC

PAC GM6A-RST Manual

19 Februar 2025
PAC

PAC SWI-X Manual

19 Februar 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

IFM

IFM SU9030 Manual

13 September 2025
IFM

IFM O2U554 Manual

13 September 2025
Speco Technologies

Speco Technologies HTi70TM Manual

13 September 2025
QSC

QSC RMXa Manual

13 September 2025
Tineco

Tineco Floor One S2 Series Manual

13 September 2025
Tineco

Tineco Floor One S3 Breeze Manual

13 September 2025
Tineco

Tineco Floor One S5 Steam Manual

13 September 2025
Osram

Osram VX500-CB Manual

13 September 2025
Zelmer

Zelmer ZTS7990 Manual

13 September 2025
Osram

Osram VX250-SP Manual

13 September 2025