PAC OnStar OS-3BOSE Manual

PAC Ikke kategoriseret OnStar OS-3BOSE

Læs gratis den danske manual til PAC OnStar OS-3BOSE (3 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 36 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 18.5 anmeldelser. Har du et spørgsmål om PAC OnStar OS-3BOSE, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/3
Paci c Accessory Corporation - 1502 S. Santa Fe Street, Santa Ana, CA 92705
techsupport@pac-audio.com • Voice: 714-835-3022 • Fax: 714-835-3233 • www.pac-audio.com Page 1
11-01-06
The OS-3BOSE is a plug and play interface that allows replacement of a General Motors GMLAN factory radio. It will
maintain operation of the OnStar® system, Bose® amplifi er and speakers. The OS-3BOSE has on board switching
to allow audio from the OnStar® system to play through the two front factory speakers when OnStar® is active. This
interface retains all warning chimes, the audible turn signal indicators, and the Vehicle Rear Parking Assist System (if
equipped). Rear Seat Audio headphone jacks will also remain active and are designed for use with dual zone radios.
Step 1- Pre wire the RAD-18 wire harness to the aftermarket stereo wire harness. Refer to installation notes on page 3 for special instruc-
tions
Step 2- After connecting the RAD-18 and OS-GM14 wire harness to the OS-3BOSE main interface, connect the OS-GM14 connector to
the factory harness.
OS-3BOSE
General Motors Bose® and OnStar® Interface
Installation Instructions for GMLAN Vehicles
Pacific Accessory Corporation
Pacific Accessory Corporation
The Following General Motors Vehicles using the GMLAN Data Bus
Chevrolet: Suburban (2007) Tahoe (2007) Avalanche (2007) Monte Carlo (2006-2007) Silverado - not classic (2007) Impala (2006-2007)
GMC: Acadia (2007) Yukon Denali (2007) Yukon (2007) Sierra - not classic (2007)
Cadillac: Escalade - including ESV and EXT (2007)
Buick: Lucerne (2006-2007)
1. The OS-3BOSE does not retain the factory XM receiver. You will lose the XM option when the factory radio is replaced with an aftermar-
ket radio.
2. You may use this interface if the vehicle does not have OnStar® but you need to interface with the Bose® ampli er.
3. If you are not retaining the Bose® ampli er, use the OS-3 interface instead of this OS-3BOSE interface.
4. This interface retains the 5.1 audio system in the Cadillac Escalade.
5. Built in Smart Mute Circuitry will play OnStar® through the front speakers and allow the Rear Seat Audio jacks to continue playing the
source selected at the radio.
• OnStar® active LED and Ignition on LED.
• Provides +12v switched accessory output. No more searching for switched +12v in fuse box or kick panel.
• OnStar® Volume control via factory steering wheel audio controls on Premium Bose® vehicles. Steering wheel radio controls can be
retained to control new radio by using the SWI - X, JACK, ECL2 or PS.
• New radio will operate with the vehicle RAP (Retained Accessory Power) system. The radio stays on after the key is turned off and stays
on for approximately 10 minutes or until the drivers door is opened.
1
1
0
0 0
0
0
0
1
1
1
0
0
0
1
1
1
1 0
0
0
0
0
0 0
0
1
0
0
1
1 0
0
1
1 0
0 1
0 0
0 0
1
0
1 0
1
0 0
1
0
0
C
a
C
a
0
Note: The Blue/White remote wire must be connected to the new radios amp remote turn on wire.
The Lt. Green wire is a SWC output wire. Do not connect this wire to anything other than the green interface wire of a SWI - X, ALP, ECL,
or PS. Program the SWC interface for version #2 and do not cut the Brown SWI interface loop. When pushing the steering wheel buttons
during programming, a simple press and release of the button will do just  ne, no need to hold. The rear controls (if equipped) will perform
the same functions as the steering wheel buttons without any additional programming necessary. If steering wheel controls are not retained
or present, isolate this wire and do not use!
Wire locations and Description
WIRE COLOR CIRCUIT CIRCUIT WIRE COLOR
9 18
8 17
7 16
6 15
5 14
4 13
3 12
2 11
1 10
PIN NUMBER
SWC Output
Chime Module
White/Black
Grey/Black
Green/Black
Purple/Black
Black
Lt. Green
Orange
Blue/White
Red
Left Front(-)
Right Front (-)
Left Rear (-)
Right Rear(-)
Ground
Illumination
Amp Turn On
+12v Accessory Output
Left Front (+)
Right Front (+)
Left Rear (+)
Chime Module
Right Rear (+)
+12v Constant
White
Grey
To CM - X
Green
To CM - X
Purple
Yellow
N/A
N/A
Not Used
Not Used
WIRE COLOR CIRCUIT CIRCUIT WIRE COLOR
Orange Illumination
8 16
Purple/White GMLan
7 15
+12v Constant Yellow
Black Ground
6 14
Amplifier Turn On Blue
Purple/Black Right Rear (-)
5 13
Right Rear (+) Purple
Green/Black Left Rear (-)
4 12
Left Rear (+) Green
OnStar Mono(-)
3 11
OnStar Mono(+)
Grey/Black Right Front (-)
2 10
Right Front (+) Grey
White/Black Left Front (-)
1 9
Left Front (+) White
PIN NUMBER
Purple/WhiteWhite/Brown
Amp Control Black
RAD - 18
OS-GM14
Notes
Supported Vehicles
Installation
Paci c Accessory Corporation - 1502 S. Santa Fe Street, Santa Ana, CA 92705
techsupport@pac-audio.com • Voice: 714-835-3022 • Fax: 714-835-3233 • www.pac-audio.com Page 2
11-01-06
Step 3- The CM-X is not needed when the Premium Ampli er is retained. The door chimes and audible turn signal indicators are generated
from the Bose® ampli er.
Step 4- OnStar volume can be adjusted from the steering wheel buttons when OnStar is activated (with premium Bose ampli er ® ® ®
ONLY). Turn the OnStar volume adjustment on the interface all the way up.®
Step 5- This ampli er will allow the fader and balance to work correctly. You can also use the supplied brown connector, c4, for subwoofer
control and center channel operation. These are low level mono inputs. We recommend using the center channel only if a 5.1 chan-
nel audio processor (or a dedicated center channel output) is present.
102.7 FM
Aftermarket stereo
30
8586
87
87a
Red wire to accessory
input of radio
c2
c1
OS-GM14 Harness
OnStar
Active
®
Volume
Adjust
SWC output wire
Connect to SWI - X green wire
Program for Version # 2
RAD 18
L
t
G
r
e
e
n
W
i
r
eOS - 3 BOSE
General Motors GMLan OnStar Interface®
Factory Radio Replacement
Retention of Bose Amplifier and OnStar Option® ®
Ignition
On LED
Pacific Accessory Corporation Santa Ana, Ca 92705
The CM-X is not
needed when a
Premium Amplifier
is retained
c4
(Brown)
Center
channel
sepaker
(RED) Subwoofer
(WHITE)
Step 3- The CM-X is not needed when the Premium Ampli er is retained. The door chimes and audible turn signal indicators are generated
from the Bose® ampli er.
Step 4- OnStar volume can be adjusted from the steering wheel buttons when OnStar is activated (with premium Bose ampli er ® ® ®
ONLY). Turn the OnStar volume adjustment on the interface all the way up.®
Note - Due to the design of this Premium Bose amplifi er system, there is currently no way of fading from front to rear with an ®
aftermarket radio.
102.7 FM
Aftermarket stereo
30
85
86
87
87a
Red wire to accessory
input of radio
c2
c1
OS-GM14 Harness
OnStar
Active
®
Volume
Adjust
SWC output wire
Connect to SWI - X green wire
Program for Version # 2
RAD 18
L
t
G
r
e
e
n
W
i
r
eOS - 3 BOSE
General Motors GMLan OnStar Interface®
Factory Radio Replacement
Retention of Bose Amplifier and OnStar Option® ®
Ignition
On LED
Pacific Accessory Corporation Santa Ana, Ca 92705
The CM-X is not
needed when a
Premium Amplifier
is retained
Step 3- The CM-X should be plugged into the white 2-pin connector and permanently mounted. This module will retain all warning chimes
and audible turn signal indications. There is no volume adjustment for this feature so keep that in mind when choosing a mounting
location.
Step 4- This ampli er will allow the fader to work correctly.
Step 5- ®The OnStar volume is only able to be controlled from the adjustment screw on the interface. Make sure this is set to the desired
level before mounting the interface and reassembling the dash.
102.7 FM
Aftermarket stereo
30
8586
87
87a
Red wire to accessory
input of radio
c2
c1
OS - GM14 Harness
OnStar
Active
®
Volume
Adjust
OS - 3 BOSE
General Motors GMLan OnStar Interface®
Factory Radio Replacement
Retention of Bose Amplifier and OnStar Option® ®
Ignition
On LED
Pacific Accessory Corporation Santa Ana, Ca 92705
RAD-18
CM-X
O
Chime Module
SWC output wire
Connect to SWI - X green wire
Program for Version # 2
L
t
G
r
e
e
n
W
i
r
e
Standard Bose®: Connecting to the vehicle’s Bose® ampli er (All Other Listed Vehicles)
Premium Bose®: Connecting to the vehicle’s Bose® ampli er (Denali Only)
Premium Bose®: Connecting to the vehicle’s Bose® ampli er (Escalade Only)

Produkt Specifikationer

Mærke: PAC
Kategori: Ikke kategoriseret
Model: OnStar OS-3BOSE

Har du brug for hjælp?

Hvis du har brug for hjælp til PAC OnStar OS-3BOSE stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret PAC Manualer

PAC

PAC CAM-GM51 Manual

11 Juli 2025
PAC

PAC TY1A-RS Manual

11 Juli 2025
PAC

PAC SR-F15009HX Manual

10 Juli 2025
PAC

PAC SRK-RAM13HX Manual

10 Juli 2025
PAC

PAC AAI-TY3 Manual

30 Juni 2025
PAC

PAC SRK-GM14HX Manual

10 Marts 2025
PAC

PAC C2A-CHY Manual

19 Februar 2025
PAC

PAC MCI-FD22 Manual

19 Februar 2025
PAC

PAC GM6A-RST Manual

19 Februar 2025
PAC

PAC SWI-X Manual

19 Februar 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Rowenta

Rowenta Adagio BV3101 Manual

12 August 2025
Klein Tools

Klein Tools VDV826-705 Manual

12 August 2025
Walrus Audio

Walrus Audio Canvas Clock Manual

12 August 2025
Rowenta

Rowenta Artik Ionic VU9020 Manual

12 August 2025
Slingshot

Slingshot S (2024) Manual

12 August 2025
Discover

Discover D713U Manual

12 August 2025
Tefal

Tefal Virtuo FV1712 Manual

12 August 2025
Mars Gaming

Mars Gaming MF-LINKFINITYKIT2R Manual

12 August 2025
Rowenta

Rowenta City Space Cyclonic RO2544 Manual

12 August 2025
Beverage-Air

Beverage-Air PRT2XTHC-1AS Manual

12 August 2025