PAC OnStar OS-5 Manual

PAC Ikke kategoriseret OnStar OS-5

Læs gratis den danske manual til PAC OnStar OS-5 (12 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 39 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 20 anmeldelser. Har du et spørgsmål om PAC OnStar OS-5, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/12
Pacic Accessory Corporation
® | Ontario, Ca. 91761 | Ph. 866-931-8021 | technicalsupport@pac-audio.com
©2014 Pacic Accessory Corporation
www.pac-audio.com
Rev. 052914
P ifi A C ti
Page 1
OS-5
Radio Replacement with Retention for General OnStar®
Motors Vehicles
Introduction & Features
Important Notes
Wiring Connection Chart
Illustration / Schematic
The OS-5 interface allows the replacement of a factory radio in select General Motors vehicles with 29-bit LAN radios.
Using this interface will retain factory features such as OnStar, warning chimes, Rear Seat Controls (RSC), factory XM
Radio and the BOSE amplier when the original radio is removed. The OS-5 also provides data bus driven outputs such
as retained accessory power (RAP), vehicle speed sensor (VSS), illumination, reverse trigger and parking brake.
1. The OS-5 will retain the use of the factory XM receiver. Factory SWC or RSE controls must be present for use of this feature.
2. SWI interface must be used in conjunction for SWC retention.
3. RSC buttons that are identical to the SWC will mimic the SWC function for function.
Red / White Parking Brake
Output (-)
Purple / White Vehicle Speed
Output
Blue OnStar® Volume
Adjust
Blue / White Amp Turn On Input
Orange / White Illumination Output
(+)
Green Reverse Output (+)
Brown Loop Mute Loop - See
installation note 7.
Aftermarket Radio Connections
Yellow Battery +12v
Black Ground
Red Accessory Output
White Front L + input
White / Black Front L - input
Grey Front R + input
Grey / Black Front R - input
Green Rear L + input
Green / Black Rear L - input
Purple Rear R + input
Purple / Black Rear R - input
Wiring
Aftermarket
Radio
Connections
Vehicle
Connections
Sub, Center Channel
& Rear Camera
Connections
XM Audio
Connections
Connec t to SWC
Interf ace. Pro gram
for Ve rsion 2.
OS-RADPWRAUDIO
XM R
XM L
SWC Interface
Connections
P ifi A C ti
Pacic Accessory Corporation
® | Ontario, Ca. 91767 | Ph. 866-931-8021 | technicalsupport@pac-audio.com
©2014 Pacic Accessory Corporation
www.pac-audio.com
P ifi A C ti
Rev. 052914
Page 2
OS-5
Radio Replacement with OnStar® R e t e n t i o n f o r G e n e r a l
Motors Vehicles
Installation Steps
1. Make all connections as described in the chart on page1.
2. Factory installed ampliers will determine the audio output connection. If the vehicle has a factory installed amplier use the factory
amplier audio location. If a factory installed amplier is not present use the non-amplied factory audio location.
3. If the vehicle is equipped with a Premium BOSE system, connect the subwoofer and center channel RCA inputs to the aftermarket radios.
If the aftermarket radio to be installed does not have a dedicated center channel or sub output do not use this cable. To ensure best sound
performance channel summing is not recommended. Use this cable according to the outputs that are available.
4. If the vehicle is equipped with a reverse camera and the aftermarket radio has a reverse camera input, connect the yellow RCA plug on the
brown connector to the aftermarket radios reverse camera input.
5. If the aftermarket radio is equipped with an auxiliary input and you wish to retain the factory XM tuner, plug the RCA connectors from the
interface into the radios auxiliary input.
6. Plug the CMX chime module in if necessary (If the vehicle chimes when the radio is removed the CMX is not necessary). PLEASE NOTE:
In order to get the best possible sound out of the CMX please mount it in a place free and clear of any obstructions, preferably as close as
possible to the bottom of the dash pointing down toward the oor of the vehicle.
7. The Mute loop (if not cut) will turn the accessory output off when an
OnStar® or Bluetooth call is made or received. If the aftermarket radio
has a mute input cut this loop and connect the inner brown wire (next to the blue/white wire) to the mute input.
OnStar Volume Adjustment for Vehicles w/o SWC
• If SWC buttons are not present a SPST switch (not included) can be
used to control the OnStar® audio level during an OnStar® connection.
• Connect the Blue wire in pin 6 to one side of a SPST normally open
momentary switch.
• The other side of the SPST switch will be connect to .12 volt constant
• When OnStar® is active pressing the switch will change the audio level
10 steps.
22
11 1
Level
Switch
blue
SPST N.O. switch (not included)
Connect to radio side 12 volt
constant wire
Blue wire
Wire insertion side view of
OS-5 RADPWRAUDIO
Connector
SWC Output Connector
• The OS-5 provides a SWC output connector attached to the
OS5-RADPWRAUDIO harness. For ease of installation, all necessary
connections for a SWI-X, ECL2, JACK, PS or RC have made for you.
• When using this SWC output connector the radio specic SWC
interface must be programmed for version 2 (refer to SWC interface
programming instructions for exact programming sequence).
• Both loops should also remain in tact.
• During steering wheel button assignment programming each button
should be pressed and held for 1 second after the SWC interface LED
goes out with the exception of the Speak button.
• The speak button should be pressed for less than 1 second and
released.
• Pressing the Speak button for longer than 1.5 SEC will activate
OnStar.
Connect to SWC
Interface. Program
for Version 2.
Connect to Radio
Specific SWC
Interface

Produkt Specifikationer

Mærke: PAC
Kategori: Ikke kategoriseret
Model: OnStar OS-5

Har du brug for hjælp?

Hvis du har brug for hjælp til PAC OnStar OS-5 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret PAC Manualer

PAC

PAC CAM-GM51 Manual

11 Juli 2025
PAC

PAC TY1A-RS Manual

11 Juli 2025
PAC

PAC SR-F15009HX Manual

10 Juli 2025
PAC

PAC SRK-RAM13HX Manual

10 Juli 2025
PAC

PAC AAI-TY3 Manual

30 Juni 2025
PAC

PAC SRK-GM14HX Manual

10 Marts 2025
PAC

PAC C2A-CHY Manual

19 Februar 2025
PAC

PAC MCI-FD22 Manual

19 Februar 2025
PAC

PAC GM6A-RST Manual

19 Februar 2025
PAC

PAC SWI-X Manual

19 Februar 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Advantech

Advantech MIC-3811 Manual

30 Juli 2025
Intermatic

Intermatic EI230W Manual

30 Juli 2025
Rockboard

Rockboard LED Light V2 Manual

30 Juli 2025
Advantech

Advantech USB-5817 Manual

30 Juli 2025
Electro Harmonix

Electro Harmonix 9DC-100 Manual

30 Juli 2025
Advantech

Advantech UTC-515H Manual

30 Juli 2025
Extron

Extron MGP 641 xi 5K Manual

30 Juli 2025
Festo

Festo EMME-AS-80-M-LS-AMB Manual

30 Juli 2025
Tiptop Audio

Tiptop Audio Octogain Manual

30 Juli 2025
Artec

Artec SE-ADL Manual

30 Juli 2025