PAC RP4.2-TY11 Manual

PAC Ikke kategoriseret RP4.2-TY11

Læs gratis den danske manual til PAC RP4.2-TY11 (7 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 23 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 12 anmeldelser. Har du et spørgsmål om PAC RP4.2-TY11, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/7
Radio Replacement and
Steering Wheel Control Interface
for Toyota / Lexus / Scion Vehicles
RP4.2-TY11
© 2019 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
C
Page 1
Rev: V6
Date:050319
Introduction and Features
Important Notes
The RP4.2-TY11 interface allows the replacement of a factory radio in select Toyota/Lexus/Scion vehicles and will retain
factory features such as steering wheel controls (SWC) and the factory audio amplier. This interface also allows you to
program two radio functions to each SWC button by using short press long press dual command functionality, and also
provides outputs such as: vehicle speed signal (VSS), illumination, reverse trigger and parking brake.
1. These instructions only apply to R.3.1.2.46 or later revisions. The revision info can be found on a small white sticker on the
interface and packaging.
2. Connection of the OBD connector, with the White / Red and White / Black wires, is not always necessary. Use of these wires
will be dependent on whether or not the aftermarket radio requires specic connections, and whether the vehicle provides these
outputs at the radio. See the “Installation Steps” section starting on page 3 for additional information.
3. Adjustment of the vehicle settings through the original radio’s vehicle settings menu will be disabled after installation of the new
radio. It is advised to make sure all settings are as you desire prior to removal of the original radio.
4. The RP4.2-TY11 does not retain Rear Seat Entertainment.
5. After installation, if you do not initially hear any audio, you may need to cycle the ignition again to initialize the factory amplier.
6. Speaker fading on factory amplied systems is only supported with the “amplied output” connection of the RP4.2-TY11.
7. When using real time fade, if the fader setting is biased more to the front or rear, as the radio turns on the sound may begin at
the default setting and then quickly transition to your custom setting.
8. Aftermarket radio features such as High Pass Filters (crossovers), DSP or “Network Mode” will interfere with proper fader
function. In order for the RP4.2-TY11’s fader function to work, the audio from the aftermarket radio’s output must match so it can
compare the front and rear audio levels and determine the proper fader setting for the factory amplier.
9. The USB-TY1 or USB-TY2 must be purchased in order to retain the factory USB port. Please refer to www.pac-audio.com to see
which harness you will need.
10. The CAM-TY11 or CAM-TY12 must be purchased in order to retain the factory reverse camera. Please refer to
www.pac-audio.com to see which harness you will need. If the required harness is not available, it is possible to hardwire the
reverse camera using the information provided in Appendix A on Page 7.
Module Layout
Module Status LED
USB Status LED
Interface Connector 1
Expansion Port
Interface Connector 2
Amplied Audio Output
Non-Amplied Audio Output
Programming Button
USB Port
Radio Select DIP switches
Interface Connector 4
Amplied Audio Output Level Adjustment
Radio Replacement and
Steering Wheel Control Interface
for Toyota / Lexus / Scion Vehicles
RP4.2-TY11
© 2019 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
C
Page 2
Rev: V6
Date:050319
Interface Connectors
Plug Interface Connectors 1, 2 and 4 into the appropriate port on the RP4.2-TY11 interface (using the diagram on page 1 or
the label on the bottom of the RP4.2-TY11 interface). The Connector 3 connection will be dependent upon whether or not the
vehicle has a factory amplied system. Connect to the appropriate port on the RP4.2-TY11.
Vehicle Connectors
Depending on the application, the
RP4.2-TY11 will need 2 or 3 of the
5 vehicle connectors. The additional
connectors will be left unused on
the harness. Any additional radio
harnesses in the vehicle that do
not plug into one of the vehicle
connectors shown above, will not
be used. Below you will nd the
combinations needed for most
vehicles.
Interface Connector 1 Interface Connector 2 Interface Connector 4
Interface Connector 3
Vehicle Connector 1 Vehicle Connector 2 Vehicle Connector 3 Vehicle Connector 4 Vehicle Connector 5
Combination 1
Typical 2004 to 2013 NON-AMPLIFIED
Vehicle Connector 3 Vehicle Connector 4 Vehicle Connector 5
Combination 2
Typical 2004 to 2013 AMPLIFIED
Vehicle Connector 1 Vehicle Connector 3
Combination 3
Typical 2014 to 2017 AMPLIFIED AND NON-AMPLIFIED
Vehicle Connector 2 Vehicle Connector 4 Vehicle Connector 5
Combination 4
Non-Typical 2012 to 2014 AMPLIFIED
Vehicle Connector 2
Vehicle Connector 1
*OBD-2 V3 *The OBD-2 V3 harness provides
CAN bus from the vehicle to the
RP4.2-TY11 for select vehicles
that do not already provide CAN
bus to the radio. Only use the
OBD-2 V3 if the aftermarket radio
requires connections for Vehicle
Speed Sense, Parking Brake, or
Reverse Signal for the following
applications:
1. Combination 1 from below.
2. Combination 2 from below.

Produkt Specifikationer

Mærke: PAC
Kategori: Ikke kategoriseret
Model: RP4.2-TY11

Har du brug for hjælp?

Hvis du har brug for hjælp til PAC RP4.2-TY11 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret PAC Manualer

PAC

PAC CAM-GM51 Manual

11 Juli 2025
PAC

PAC TY1A-RS Manual

11 Juli 2025
PAC

PAC SR-F15009HX Manual

10 Juli 2025
PAC

PAC SRK-RAM13HX Manual

10 Juli 2025
PAC

PAC AAI-TY3 Manual

30 Juni 2025
PAC

PAC SRK-GM14HX Manual

10 Marts 2025
PAC

PAC C2A-CHY Manual

19 Februar 2025
PAC

PAC MCI-FD22 Manual

19 Februar 2025
PAC

PAC GM6A-RST Manual

19 Februar 2025
PAC

PAC SWI-X Manual

19 Februar 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Navman

Navman MY500XT Manual

1 August 2025
Navman

Navman FOCUS150 GPS Manual

1 August 2025
Scheppach

Scheppach TW1000 Manual

1 August 2025
Navman

Navman MiVue 750 WIFI Manual

1 August 2025
Navman

Navman MiVue Drive FHD Manual

1 August 2025
Midea

Midea MEC64 Manual

1 August 2025
Navman

Navman MY50T Manual

1 August 2025
Navman

Navman M100 Manual

1 August 2025
Navman

Navman MiVue 770 SAFETY Manual

1 August 2025
Navman

Navman MiVue 790 Manual

1 August 2025