Wavtech Link1000.5plus Manual

Wavtech Modtager Link1000.5plus

Læs gratis den danske manual til Wavtech Link1000.5plus (8 sider) i kategorien Modtager. Denne vejledning er vurderet som hjælpsom af 35 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 18 anmeldelser. Har du et spørgsmål om Wavtech Link1000.5plus, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/8

Owner’s Manual

1000W RMS 5-Channel Ampliﬁer

link1000.5plus

www.wavtech-usa.com

• DO NOT DRIVE WHILE DISTRACTED. Any function that requires your prolonged attention should not be

performed while driving. Always stop the vehicle in a safe location before performing any such function. Failure to

do so may result in an accident.

• KEEP THE VOLUME AT MODERATE LEVELS WHILE DRIVING. Excess volume levels can obscure sounds such as

emergency vehicle sirens or road warning signals and may result in an accident. Continuous exposure to high sound

pressure levels may cause permanent hearing loss. Use common sense and practice safe sound.

• FOR USE WITH 12V NEGATIVE GROUND VEHICLE APPLICATIONS ONLY. Using this product other than in its

designed application may result in ﬁre, injury or product damage.

• MAKE THE CORRECT WIRING CONNECTIONS AND USE PROPER FUSE PROTECTION. Failure to connect wiring

correctly with appropriate gauge and fuse protection may result in ﬁre, injury or product damage . When replacing

fuse(s), never exceed the speciﬁed rating. Ensure proper protection of all system power wiring and install an

external fuse (not included) with speciﬁed rating for each ampliﬁer connected with the +12V lead at the battery

terminal.

• DISCONNECT THE NEGATIVE BATTERY TERMINAL BEFORE INSTALLATION. Failure to do so may result in ﬁre,

injury or damage to the unit.

• D O NOT ALLOW CABLES TO BECOME ENTANGLED IN SURROUNDING OBJECTS. Arrange wiring and cables to

prevent obstructions when driving. Cables or wiring that obstruct or hang up on places such as steering wheel,

brake pedals, etc. can be extremely hazardous.

• DO NOT DAMAGE VEHICLE SYSTEMS OR WIRING WHEN DRILLING HOLES. When drilling holes in the chassis

for installation, take precautions so as not to contact, puncture or obstruct brake lines, fuel lines, fuel tanks,

electrical wiring, etc. Failure to take such precautions may result in ﬁre or an accident.

• DO NOT UTILIZE OR CONNECT TO ANY PART OF VEHICLE SAFETY SYSTEMS. Bolts, nuts or wires used in the

brake, airbag, steering or any other safety-related systems or fuel tanks should NEVER be used for mounting,

power or ground connections. Using such parts may disable control of the vehicle or result in ﬁre.

WARNING This symbol means important instructions.

Failure to heed them can result in serious injury or death.

CAUTION

• STOP USE IMMEDIATELY IF A PROBLEM OCCURS. Failure to do so may result in personal injury or damage to the

product. Return it to your authorized Wāvtech dealer.

• HAVE AN EXPERT DO THE WIRING AND INSTALLATION. This unit requires special technical skill and experience

for wiring and installation. To insure safety and proper function, always contact the authorized dealer where you

purchased the product to have it done professionally.

• INSTALL THE UNIT SECURELY WITH SPECIFIED PARTS. Be sure to use only the included parts and speciﬁed

installation accessories (not included). Use of other than designated parts may damage this unit. Install the unit

securely so that it will not come loose during a collision or sudden jolt.

• ROUTE WIRING AWAY FROM SHARP EDGES AND MOVING PARTS. Arrange cables and wiring away from sharp

or pointed edges and avoid moving parts such as seat hinges or rails to prevent pinching or wear. Use loom

protection where appropriate and always use a grommet for any wiring routed through metal.

• NEVER RUN SYSTEM WIRING OUTSIDE OR UNDERNEATH THE VEHICLE. All wiring must be routed, secured

and protected inside the vehicle. Failure to do so may result in ﬁre, injury or property damage.

• INSTALL THE UNIT IN A DRY AND VENTILATED LOCATION. Avoid mounting locations where the unit will likely

be exposed to high moisture or heat without adequate ventilation. Moisture penetration or heat buildup may

result in product failure. Always make sure the ampliﬁer chassis temperature is safe before touching it.

• REDUCE GAIN AND SOURCE VOLUME TO MINIMUM LEVELS FOR INITIAL SYSTEM TUNING. Ensure ampliﬁer

power is oﬀ before connecting signal cables and follow proper system gain setting procedures. Failure to do so

may result in damage to the ampliﬁer and/or connected speakers.

Package Contents: Accessories Required for

Installation (not included):

WARNING

CAUTION

This symbol means important instructions.

Failure to heed them can result in injury or property damages.

Mounting Tabs

(pre-attached)

Spk Level

Input Terminals

Main Unit

Hex Wrenches

ŸRCA Cables or Signal Wire

ŸPower Supply & Speaker Wire

ŸIn-line Fuse Holder w/100A Fuse

ŸBattery Ring Terminal

ŸChassis Ground Terminal

ŸWire Crimp Connectors

ŸGrommets & Loom

Mounting Screws

Produkt Specifikationer

Mærke:	Wavtech
Kategori:	Modtager
Model:	Link1000.5plus

Har du brug for hjælp?

Hvis du har brug for hjælp til Wavtech Link1000.5plus stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Modtager Wavtech Manualer

Wavtech link700.4plus Manual

13 Januar 2025

Wavtech Link1000.5plus Manual

1 Januar 2025

Wavtech Link300.4 mini Manual

27 August 2024

Wavtech Link500.1 mini Manual

27 August 2024

Modtager Manualer

Nyeste Modtager Manualer

Rane Zone Power Eight Manual

14 Juni 2025

Blaupunkt Melbourne 130 Manual

14 Juni 2025

NVX NDA12001 Manual

14 Juni 2025

Denon AVC-1930 Manual

14 Juni 2025

Blaupunkt Kansas City 910 Manual

13 Juni 2025

Planet Audio PL3000.2 Manual

13 Juni 2025

AEA 1029 Manual

13 Juni 2025

Planet Audio AC1000.2 Manual

13 Juni 2025

Blaupunkt Osaka 110 Manual

13 Juni 2025

Blaupunkt Kansas City 920 Manual

13 Juni 2025