
SHAW DIRECT Reector and Bracket Installation
Check to be sure that there is nothing above the TRAV’LER antenna that might
prevent it from raising. You will need at least 40” of clearance above the TRAV’LER
mount to ensure that you have room to install the reector. Pay attention to these Pinch
Points as the antenna raises.
There are two ways to raise the antenna, automatic or manual; each is explained below.
Steps 1-7 explain how to use the TRAV’LER Interface Box to raise the mount.
1. Press and hold for 2 seconds to turn “ON” the TRAV’LER Interface Box. Wait until the [POWER]
InterfaceBoxnishes“connectingtoantenna”.
* The TRAV’LER may enter the “Search Routine” after 10 seconds; this is normal (See NOTE Below).
2. Press [ENTER] and hold for 2 seconds or until the unit displays “Enter User Menu”. Press [SELECT] to
move the asterisk to “Yes”. Press [ENTER].
3. Press to move the asterisk to INSTALLATION.[SELECT]
4. Press You will be asked to provide a code to enter the Installation Menu.[ENTER].
5. Press 4 times to enter code 0000. [ENTER]
6. Press to move the asterisk to RAISE ANTENNA. Press Press to move [SELECT] [ENTER]. [SELECT]
7. Press The TRAV’LER mount will raise up about half way. [ENTER].
* NOTE: If the TRAV’LER enters the “Search Routine,” and the TRAV’LER mount raises more than 1/2 way be-
fore RAISE ANTENNA is selected (See Step 6), the TRAV’LER will hit its Upper Hard Stop and “Motor Stall” will
The “Motor Stall” means the TRAV’LER is all the way up and the mount cannot raise any more. There are two
easy ways to clear the “Motor Stall”.
a. Press [ENTER] the TRAV’LER antenna will return to the “Installation Menu”
b. Press [POWER] the TRAV’LER antenna will stow and turn “OFF” (Restart at Step 1).
NOTE: Pinch Points are called out both for your safety and to protect the cables. Ca-
bles will be damaged if installed incorrectly. See pages 3-4 in this installation manual.