PAC GM3A-RSTX Manual

PAC Ikke kategoriseret GM3A-RSTX

Læs gratis den danske manual til PAC GM3A-RSTX (6 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 12 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 6.5 anmeldelser. Har du et spørgsmål om PAC GM3A-RSTX, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/6
Radio Replacement and Steering Wheel Control Interface
with OnStar Retention for General Motors Vehicles
GM3A-RSTX
© 2018 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
C
Page 1
Rev: 1
Date: 100318
Introduction and Features
Important Notes
Wiring Connection Chart
Illustration / Schematic
The GM3A-RSTX interface allows the replacement of a factory radio in select General Motors vehicles with 29-bit LAN
radios. Using this interface will retain factory features such as OnStar, steering wheel controls (SWC), warning chimes,
Rear Seat Controls (RSC), factory XM Radio and the BOSE amplier when the original radio is removed. Use of this
interface also allows you to program two radio functions to each SWC button by using short press long press dual
command functionality. The GM3A-RSTX also provides data bus driven outputs such as retained accessory power
(RAP), vehicle speed signal (VSS), illumination, reverse trigger and parking brake.
1. These instructions only apply to R.2.6.6.19 or later revisions. The revision info can be found on a small white sticker on the
interface and packaging.
2. The radio select rotary switch on the side of the interface must be adjusted to the proper radio setting before plugging the
interface into the vehicle (see next page for setting chart).
3. The interface comes pre-programmed for all of the vehicles factory SWC functions and does not require programming unless
you wish to re-assign the SWC functions or utilize short press long press dual command functionality. The SWC can always be
restored to default settings by following the procedure outlined on page 2.
4. RSC buttons that are identical to the SWC will mimic the SWC one for one.
5. The LED will ash whenever a SWC button is pressed.
Light Green Parking Brake Output (-)
Pink Vehicle Speed Output
Blue Not Used
Blue / White Amp Turn On Input
Orange / White Illumination Output (+)
Purple / White Reverse Output (+)
Brown Loop Mute Loop - See
installation note 8.
Aftermarket Radio Connections
Yellow * +12v from RP Advanced
Yellow * +12v from vehicle
Black ** Ground from RP Advanced
Black ** Ground from vehicle
Red Acc. Output
White Front Left + input
White / Black Front Left - input
Grey Front Right + input
Grey / Black Front Right - input
Green Rear Left + input
Green / Black Rear Left - input
Purple Rear Right + input
Purple / Black Rear Right - input
SWC Connector
Blue / Yellow Kenwood, Newer JVC
3.5mm Jack
Alpine, JVC, Clarion,
Pioneer, Sony, Fusion,
Boyo, Dual, Lightning
Audio, Visteon or
Advent
SWC Connection
See above chart for
different radio type
connections
Wiring SWC Connection
XM R
XM L
Aftermarket
Radio
Connections
Vehicle
Connections
P ifi A C ti
IMPORTANT NOTES REGARDING YELLOW AND BLACK WIRE CONNECTIONS
* Connect both Yellow wires from the RP Advanced harnesses to the radio’s 12v
constant input
** Connect both Black wires from the RP Advanced harnesses to the radio’s ground
input.
Factory reverse camera and
auxiliary input retention harness
Power and speaker
connections
Radio Replacement and Steering Wheel Control Interface
with OnStar Retention for General Motors Vehicles
GM3A-RSTX
© 2018 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
C
Page 2
Rev: 1
Date: 100318
Installation Steps
1. The radio select rotary switch on the side of the interface must be adjusted to the proper radio
setting before plugging the interface into the vehicle.
2. Make all connections as described in the chart on page 1. Be sure to connect both Yellow wires (one from vehicle harness and one from RP
Advanced harness) and both Black wires (one from vehicle harness and one from RP Advanced harness) while making these connections.
3. Factory installed ampliers will determine the audio output connection. If the vehicle has a factory installed amplier, use the factory
amplier audio location. If a factory installed amplier is not present, use the non-amplied factory audio location.
4. If the vehicle is equipped with a Premium BOSE system, connect the subwoofer and center channel RCA inputs to the aftermarket radio. If
the aftermarket radio to be installed does not have a dedicated center channel or sub output, do not use this cable. To ensure best sound
performance, channel summing is not recommended. Use this cable according to the outputs that are available.
5. If the vehicle is equipped with a reverse camera and the aftermarket radio has a reverse camera input, connect the Yellow RCA plug on the
Brown connector to the aftermarket radio’s reverse camera input.
6. If the aftermarket radio is equipped with an auxiliary input and you wish to retain the factory XM tuner, plug the RCA connectors from the
interface into the radio’s auxiliary input.
7. Plug the CMX chime module in if necessary (If the vehicle chimes when the radio is removed, the CMX is not necessary). PLEASE NOTE:
In order to get the best possible sound out of the CMX, please mount it in a place free and clear of any obstructions, preferably as close as
possible to the bottom of the dash pointing down toward the oor of the vehicle.
8. The Mute loop (if not cut) will turn the accessory output off when an OnStar or Bluetooth call is made or received. If the aftermarket radio
has a mute input cut this loop and connect the inner Brown wire (next to the Blue / White wire) to the mute input.
9. Connect the SWC wire according to the chart on page 1 (aftermarket radio MUST support a wired remote input).
10. If you wish to reassign functions to the SWC follow the programming instructions in the next section.
IMPORTANT! The interface comes pre-programmed for the functions listed in the chart below and does not require programming
unless you wish to re-assign the SWC functions, or utilize short press long press dual command functionality. The SWC can
always be restored to default settings by pressing the program button on the side of the interface once and waiting for the timeout.
Alpine JVC Kenwood Clarion Pioneer Sony Fusion
Volume +
Volume + Volume + Volume + Volume + Volume + Volume + Volume +
Volume -
Volume - Volume - Volume - Volume - Volume - Volume - Volume -
Source Source Source Source Source Source Source
Track +
Track + Track + Track + Search + Track + Track + Track +
Track -
Track - Track - Track - Search - Track - Track - Track -
Voice
Voice Voice Voice Voice Voice Voice Mute
Play/Pause Preset + Preset/Disc - Disc/FM+ Band Preset + Preset + Audio
Default Steering Wheel Control Programming
Default SWC Button Assignments
Optional Steering Wheel Control Programming
If you wish to re-assign the SWC functions, utilize short press long press dual command functionality or select between Factory/
Aftermarket mode, the interface must be programmed in the specic order shown in the chart on page 4. If you come across a
function in the chart that your steering wheel does not have, or you do not want to program, press and release the program button
on the side of the interface to skip that function. The LED will ash off and on conrming that you have successfully skipped that
function and are ready to proceed to the next one.
1
2
3
4
5
6
7
8
9
0
Alpine JVC Kenwood /
Lightning Audio
Clarion /
Nakamichi
Pioneer /
Other* Sony Fusion
1 2 3 4 7 8 9
*Other - Dual / Axxera, Jensen, Rockford Fosgate
SET RADIO SELECT SWITCH

Produkt Specifikationer

Mærke: PAC
Kategori: Ikke kategoriseret
Model: GM3A-RSTX

Har du brug for hjælp?

Hvis du har brug for hjælp til PAC GM3A-RSTX stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret PAC Manualer

PAC

PAC CAM-GM51 Manual

11 Juli 2025
PAC

PAC TY1A-RS Manual

11 Juli 2025
PAC

PAC SR-F15009HX Manual

10 Juli 2025
PAC

PAC SRK-RAM13HX Manual

10 Juli 2025
PAC

PAC AAI-TY3 Manual

30 Juni 2025
PAC

PAC SRK-GM14HX Manual

10 Marts 2025
PAC

PAC C2A-CHY Manual

19 Februar 2025
PAC

PAC MCI-FD22 Manual

19 Februar 2025
PAC

PAC GM6A-RST Manual

19 Februar 2025
PAC

PAC SWI-X Manual

19 Februar 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Advantech

Advantech MIC-3811 Manual

30 Juli 2025
Intermatic

Intermatic EI230W Manual

30 Juli 2025
Rockboard

Rockboard LED Light V2 Manual

30 Juli 2025
Advantech

Advantech USB-5817 Manual

30 Juli 2025
Electro Harmonix

Electro Harmonix 9DC-100 Manual

30 Juli 2025
Advantech

Advantech UTC-515H Manual

30 Juli 2025
Extron

Extron MGP 641 xi 5K Manual

30 Juli 2025
Festo

Festo EMME-AS-80-M-LS-AMB Manual

30 Juli 2025
Tiptop Audio

Tiptop Audio Octogain Manual

30 Juli 2025
Artec

Artec SE-ADL Manual

30 Juli 2025