PAC LCGM24 Manual


Læs gratis den danske manual til PAC LCGM24 (1 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 19 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 10 anmeldelser. Har du et spørgsmål om PAC LCGM24, eller vil du spørge andre brugere om produktet?

Side 1/1
LCGM24
Radio Replacement Interface for General Motors Vehicles
Pacic Accessory Corporation
® | Santa Ana, California 92705 | Ph. 866-931-8021 | support@pac-audio.com
©2013 Pacic Accessory Corporation
www.pac-audio.com
Rev. 050213
P ifi A C ti
P ifi A C ti
The LCGM24 allows the replacement of a factory radio in select General Motors vehicles with Class II radios. Using this interface
will retain factory features such as warning chimes and provides a data-bus generated 12-volt retained accessory power output
(RAP). RAP keeps the radio powered after key-off, just like the factory system. The LCGM24 also issues data commands that
maintain a “healthy” system status to other vehicle systems.
Introduction & Features
Installation Steps
PLEASE NOTE: This Interface is intended
for use in vehicles without OnStar® or
Bose® or when OnStar® or Bose® does
not need to be retained.
1. Wire your aftermarket radio to the LCGM24’s
harness according to the wiring connections chart.
The red accessory wire will support up to 10 amps
of current draw.
2. Remove the factory radio and plug in the LCGM24’s
24-pin harness into the factory vehicle harness.
Using the supplied length of wire, mount the
interface within the dash of the vehicle with double
sided tape or wire ties. There are no adjustments
to make, just mount your aftermarket radio and re-
install your factory dash panels and youre done!
1. Turn the ignition on. The LED on the interface will turn on & the +12v accessory wire will turn on.
2. Turn on the radio & check balance & fade.
3. Turn off vehicle & remove key. RAP will be active & keep the radio on for 10 minutes or until the drivers door is opened.
4. The LED & radio will turn off when RAP turns off or the drivers door is opened.
Testing & Verication
Illustration / Schematic
Yellow Battery +12v
Black Ground
Red Accessory +12v
(10A)
Blue Antenna On Input
White Front L + input
White / Black Front L - input
Grey Front R + input
Grey / Black Front R - input
Green Rear L + input
Green / Black Rear L - input
Purple Rear R + input
Purple / Black Rear R - input
Wiring Connections
Aftermarket Radio
Connections
To Vehicle
Connector


Produkt Specifikationer

Mærke: PAC
Kategori: Ikke kategoriseret
Model: LCGM24

Har du brug for hjælp?

Hvis du har brug for hjælp til PAC LCGM24 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret PAC Manualer

PAC

PAC CAM-GM51 Manual

11 Juli 2025
PAC

PAC TY1A-RS Manual

11 Juli 2025
PAC

PAC SR-F15009HX Manual

10 Juli 2025
PAC

PAC SRK-RAM13HX Manual

10 Juli 2025
PAC

PAC AAI-TY3 Manual

30 Juni 2025
PAC

PAC SRK-GM14HX Manual

10 Marts 2025
PAC

PAC C2A-CHY Manual

19 Februar 2025
PAC

PAC MCI-FD22 Manual

19 Februar 2025
PAC

PAC GM6A-RST Manual

19 Februar 2025
PAC

PAC SWI-X Manual

19 Februar 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer