PAC OS-5 Manual

PAC Ikke kategoriseret OS-5

Læs gratis den danske manual til PAC OS-5 (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 9 personer og har en gennemsnitlig bedømmelse på 3.7 stjerner ud af 5 anmeldelser. Har du et spørgsmål om PAC OS-5, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

OS-5

Radio Replacement Interface with

Telematics Retention

For select General Motors Vehicles

With 29 Bit Data Systems

PAC-audio.com

Rev: V1

Date: 12/17/2021 Page 1

Introduction and Features

Important Notes

1. Aftermarket radio must have an auxiliary input in order to retain RSE audio.

2. If the vehicle chimes when the radio is removed, the CMX is not necessary. In order to get the best possible sound out of the

CMX, please mount it in a place free and clear of any obstructions, preferably as close as possible to the bottom of the dash

pointing down toward the oor of the vehicle.

Module Layout

Programming Button

USB Port

Radio Select DIP switches

Interface Connector 4

Adjustment Dial

Module Status LED

USB Status LED

Interface Connector 1

Not Used

Interface Connector 2

Amplied Audio Output Connector 3

Non-Amplied Audio Output

The OS-5 interface allows the replacement of a factory radio in select General Motors vehicles with 29 Bit Data-Bus. Using this

interface will retain factory features such as Warning Chimes, Bose Amplier, Rear Seat Entertainment (RSE), and Rear Seat

Controls (RSC) when the original radio is removed. The OS-5 provides data bus driven outputs such as retained accessory power

(RAP), vehicle speed signal (VSS), illumination, reverse trigger and parking brake.

OS-5

Radio Replacement Interface with

Telematics Retention

For select General Motors Vehicles

With 29 Bit Data Systems

PAC-audio.com

Rev: V1

Date: 12/17/2021 Page 2

Installation Steps

1. Wire your aftermarket radio to the OS-5’s harness according to the wiring connections chart below.

2. The Brown mute loop in Interface Connector 4 (if not cut) will turn the OS-5’s accessory output off when any OnStar

function is active. If the aftermarket radio has a mute input, cut this loop and connect the Brown wire in pin 23 to it. This pin

is located in the top row next to the solid blue wire. (The top of the connector has the locking tab on it).

3. Plug Interface Connectors 1 and 2 into the appropriate ports on the OS-5 interface (using the diagram on Page 1 or the

label on the bottom of the interface).

4. The Connector 3 connection will be dependent upon whether or not the vehicle has a factory amplied system. Plug this

connector into the appropriate port on the OS-5 (using the diagram on Page 1 or the label on the bottom of the interface).

5. If the aftermarket radio is equipped with an auxiliary input and you wish to retain the factory RSE audio, you must use the

part# GMRVD (Sold Separately).

6. Remove the factory radio and plug in the OS-5’s Vehicle and Vehicle Connector 1 Connector 2 into the factory vehicle

harness.

7. Plug the 2-Pin connector into the CMX Chime Module (If the vehicle chimes when the radio is removed, the CMX is not

necessary). PLEASE NOTE: In order to get the best possible sound out of the CMX, please mount it in a place free and clear

of any obstructions, preferably as close as possible to the bottom of the dash pointing down toward the oor of the vehicle.

Interface Connector 1

(3-pin)

Interface Connector 2

(20-pin)

Interface Connector 4

(24-pin)

Interface Connector 3

(12-pin)

Yellow 12v+

Red Accessory Output

(10 amp)

Black Ground

Brown Loop Mute Output

Blue Not Used

Blue / White Remote On Input

Orange Not Used

Orange / White Illumination Output

Purple / White Reverse Output (+)

Light Green Parking Brake Output (-)

Pink Vehicle Speed Signal

(VSS) Output

Blue / Yellow SWC Output / Key 1

Brown SWC Output / Key 2

3.5 mm Jack SWC Output

Purple Rear R + input

Purple / Black Rear R - input

Green Rear L + input

Green / Black Rear L - input

Gray Front R + input

Gray / Black Front R - input

White Front L + input

White / Black Front L - input

Wiring Connections

CMX Chime Module

Vehicle Connector 1

(14-pin)

Vehicle Connector 2

(16-pin)

Produkt Specifikationer

Mærke:	PAC
Kategori:	Ikke kategoriseret
Model:	OS-5

Har du brug for hjælp?

Hvis du har brug for hjælp til PAC OS-5 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret PAC Manualer

PAC CAM-GM51 Manual

11 Juli 2025

PAC TY1A-RS Manual

11 Juli 2025

PAC SR-F15009HX Manual

10 Juli 2025

PAC SRK-RAM13HX Manual

10 Juli 2025

PAC AAI-TY3 Manual

30 Juni 2025

PAC SRK-GM14HX Manual

10 Marts 2025

19 Februar 2025

19 Februar 2025

19 Februar 2025

19 Februar 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Gourmia GDK2375 Manual

12 August 2025

Mars Gaming MT0X3 Manual

12 August 2025

Smart-AVI EKS-1602 Manual

12 August 2025

ENDORFY Supremo FM5 HPWR cable Manual

12 August 2025

Lorex AJLD-1B2 Manual

12 August 2025

Beverage-Air RI18HC-HS Manual

12 August 2025

Dito Sama 600443 Manual

12 August 2025

Beverage-Air PHI2-1S-PT Manual

12 August 2025

Chamberlain CHU48C Manual

12 August 2025

PDP Rock Candy Wired Controller Manual

12 August 2025