Smart-AVI DVX-2PS Manual

Smart-AVI AV forlænger DVX-2PS

Læs gratis den danske manual til Smart-AVI DVX-2PS (2 sider) i kategorien AV forlænger. Denne vejledning er vurderet som hjælpsom af 19 personer og har en gennemsnitlig bedømmelse på 3.8 stjerner ud af 10 anmeldelser. Har du et spørgsmål om Smart-AVI DVX-2PS, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

User Manual

DVX-2P

Extend 2 DVI-D, RS232, Stero Audio and USB1.1 using a

Single Enclosure

Please visit smartavi.com for a expanded version of this manual.

m_dvx2p_101209

Specifications

PIN 17

PIN 1

PIN 24

PIN 8

C 4

C 1

C 2

C 5

C 3

#niP langiS #niP langiS

1 -2ataDS.D.M. 6T 1 tceteDgulPtoH

2 +2ataDS.D.M. 7T 1 -0ataDS.D.M.T

d3 leihS4/2ataDS.D.M. 8T 1 +0ataDS.D.M.T

4 -4ataDS.D.M. 9T d1 leihS5/0ataDS.D.M.T

5 +4ataDS.D.M. 0T 2 -5ataDS.D.M.T

6 kcolCCD 1D 2 +5ataDS.D.M.T

7 ataDCD 2D d2 leihSkcolCS.D.M.T

8 cnyS.treVgolan 3A 2 +kcolCS.D.M.T

9 -1ataDS.D.M. 4T 2 -kcolCS.D.M.T

01 +1ataDS.D.M.T

1 d1 leihS3/1ataDS.D.M. 1T C deRgolanA

21 -3ataDS.D.M. 2T C neerGgolanA

31 +3ataDS.D.M. 3T C eulBgolanA

41 rewoPV5 4+ C cnySzroHgolanA

51 DN 5G C dnuorGgolanA

5VDC 1.6A

DVI

Video Interface DVI-D

Resolution 1920 x 1200@60Hz, Resolution up to 1280 x

1024 min. 75Hz

Input Interface DVI-D (Single-Link)

Upgradeable Onboard Flash

USB

CAT6 (STP) Maximum Range 220ft

USB Data Data Rate of 12Mbps

Compatable with USB version 1.1

USB Connectors USB-TX-DVX-2P, Type A

USB-TX-DVX-2P, Type B

RS232 and Audio

RS232 (TX-DB9Female) (RX-DB9Male)

CAT6 STP CAT6

Protocol Full duplex, transparent to all baud rate

Audio Signal Type Stero Audio

Bandwidth 15MHz.0db

Impedance 100 Ohm

Connector 3.5 mini jack,

Power 110/120V - 5VDC - 5A

Dimension (inches) 10.81” (L) x 3.38” (W) x 1.06” (H)

Weight (lbs) 2lb

2840 N. Naomi Ave.

Burbank, California 91504

Phone: (818) 565-0011

Facsimile: (818) 565-0020

SmartAVI, Inc. / Twitter: smartavi

11651 Vanowen St. North Hollywood, CA 91605

Tel: (818) 503-6200 Fax: (818) 503-6208

http://www.SmartAVI.com

NOTICE

T h e i n f or m at i on c on t a in e d i n t h i s d oc u m e n t

is subject to change without notice. Smart-AVI makes

no warranty of any kind with regard to this material,

in cluding but not limited to, implied warran ties of

merchantability and fitness for any particular purpose.

Smart-AVI will not be liable for errors contained herein or for

incidental or consequential damages in connection with the

furnishing, performance or use of this material.

No part of this document may be photocopied, reproduced

or translated into another language without prior written

consent from Smart-AVI.

For more information, visit www.smartavi.com.

Connecting the Audio and RS232

Connecting the TX/RX

Connecting the DVI

1. Turn off computer and monitor.

2. Connect DVI male to male cable between the

computer and the transmitter.

3. Connect monitor or projector to the DVI port

on the receiver.

5. Repeat for 2 other ports.

Connect a shielded Cat 6 STP cable

between port 1 on the transmitter and port 1

on the receiver.

1. Connect an RS232 cable and/or audio cable to the

1. Connect DVI, USB (In/Out) and Audio/RS232 as outlined.

2. Connect Power Supply (5VDC - 5A).

3. Turn on TX and RX.

souce unit.

2. Connect the Audio using 3.5mm cable at the transmitter

3. Connect the Speaker/s. at the Receiver.

4. Connect the last CAT6

STP Cable. Preparing & Connecting System CAT5 Cable

Following is the wiring standard for terminating CAT 5

cable using RJ-45 connector:

Pair 1 Pins 1 & 2

Pair 2 Pins 3 & 6

Pair 3 Pins 4 & 5

Pair 4 Pins 7 & 8

Connect ors : RJ-45

Cap acitance: 14 pf/ft (46.2 pf/m)

Conductor Gauge: 24 AWG

Impedance: 100 +/- 15 ohms

4 - Pair

Note:

The receiver provides remote power up to 500

mA to the connected peripherals. This power comes

from the host computer and is passed by the transmitter

to the receiver. In some applications, and external power

supply is required. SmartAVI can provide a power supply

for such cases with the receiver and transmitter units.

1. Connect the transmitter to the host using the A-B

USB cable (included with the unit).

2. The A side of the connector would go to the com-

puter host and the B side would be connected to

the transmitter.

3. Connect the receiver to the peripheral.

4. Connect the CAT6 STP Cable.

Connecting the USB In/Out

Applications

• Film and Music Industry: Perfect for recording studios

and editing stations that need to be isolated.

Medical: In an environment where display

monitors and workstations cannot be

in close proximity of various pieces of

medical equipment.

Data Centers and Server Rooms:

Allows for users to access CPUs

from a remote work space.

Receiver

Transmitter

USB / RS232

Audio

4 STP-CAT6

DVI

DVI Audio / / USB RS232

USB

4. Connect the transmitter and receiver with 4

CAT6 STP cables.

Produkt Specifikationer

Mærke:	Smart-AVI
Kategori:	AV forlænger
Model:	DVX-2PS

Har du brug for hjælp?

Hvis du har brug for hjælp til Smart-AVI DVX-2PS stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

AV forlænger Smart-AVI Manualer

Smart-AVI HFX Manual

9 Januar 2025

Smart-AVI HFX-KM Manual

9 Januar 2025

Smart-AVI FDX-AVPRO Manual

1 Januar 2025

Smart-AVI HDX-POE Manual

1 Januar 2025

Smart-AVI RKT16-HDX100 Manual

1 Januar 2025

Smart-AVI HDX-LX Manual

1 Januar 2025

Smart-AVI SFXPRO-4P Manual

1 Januar 2025

Smart-AVI XTPRO Manual

1 Januar 2025

Smart-AVI SFXPRO-2P Manual

1 Januar 2025

Smart-AVI FVX-3000-Pro Manual

1 Januar 2025

AV forlænger Manualer

Nyeste AV forlænger Manualer

Genexis Elite HX30 Manual

8 Juni 2025

Genexis Elite HX40 Manual

8 Juni 2025

Provision-ISR PR-HDoNet+ Manual

8 April 2025

Apantac DP-FIB-II Manual

25 Februar 2025

Adder Link X-DVI PRO-DL Manual

28 Januar 2025

Adder Link X100 Manual

28 Januar 2025

Kramer EXT3-U3-T Manual

20 Januar 2025

Kopul XLR4F-RJ45 Manual

14 Januar 2025

Kopul RM-4X4XMFRJ45 Manual

13 Januar 2025

Planet VF-106G-KIT Manual

13 Januar 2025