PAC TOYK969 Manual


Læs gratis den danske manual til PAC TOYK969 (6 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 9 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 5 anmeldelser. Har du et spørgsmål om PAC TOYK969, eller vil du spørge andre brugere om produktet?

Side 1/6
CUSTOMER HELP LINE
USA 800-323-4329 • Canada 800-245-8777
TOYK969 Mounting Kit
Toyota
2007-14 FJ CRUISER
2007-14 YARIS (Excluding radio w/2”x4” LCD display)
Scion
2004-06 xA
2004-14 xB
2008-14 xD
2005-10 TC
VEHICLE APPLICATIONS
iTOYK969 ©2015 AMERICAN INTERNATIONAL INDUSTRIES, INC. TECH Ver. 10/14 PRINT Ver. 04/15
WWW.AIUS.NET
2500 East Francis Street Ontario, CA 91761, U.S.A.
USA Sales (800) 336-6500
Canada Sales (888) 922-3006
For information about other American International automotive
accessories visit our website at:
http://www.aius.net
1
DIN MOUNT INSTRUCTIONS
1. Follow instructions from steps 1&2 of ISO mount instructions below.
2. Insert DIN sleeve from your new radio into the upper section of the installation kit.
(This DIN sleeve comes with all new radios and slides off the back of the radio)
3. Depress the tabs from inside the sleeves opening upward, outward, and downward
to secure sleeve to the installation kit.
4. Install radio into sleeve and lock into place.
Optional use Trim Ring (ITR-969) may be used on some radios if desired.
Due to the movement of some faces on some radios our ISO Trim Ring may not be able
to be used. You may also ISO mount your radio. Your new radio must have a trim ring
around the face of the radio that is designed to be easily removed. Consult your radio
ownerʼs manual.
ITR-969
Trim Ring
(Optional Use)
ISO MOUNT INSTALLATION INSTRUCTIONS
Not e: Some radio faces are larger in size than the ITR-969 Trim Ring allows.
You may need to file the Trim Ring opening larger for some radios.
1. Attach the left and right side brackets to the main bracket. See illustration below.
2. Attach left and right side brackets to the rear of the pocket using screws supplied w/kit.
3. Attach ISO Mount Spacers to the inside of upper section on
both Left & Right mounting brackets as shown in Figure A.
4. Slide radio into kit from rear & attach to ISO mounting
brackets using screws supplied with radio (do not tighten
screws at this time). (Be sure the length of the screws
DO NOT touch any electrical parts inside radio, some
screws may need to be shortened.)
5. Slide radio forward or backward for your desired look and
then tighten the mounting screws. Use ISO trim ring
when possible.
NOTE: Optional ISO trim ring (ITR-969 included)
may be used in place of after-market radioʼs
trim ring. For ISO mount applications,
mount after-market radio
to side brackets using
hardware included. ITR-969
Trim Ring
(Optional Use)
Fig. A
DINSleeve
10
1. Carefully unclip and remove the soft trim piece from around the radio, airbag
light/hazard button and passenger side air vent.
2. Carefully unclip and pry forward the radio trim bezel.
3. Remove the (4) Phillips screws securing the radio to the sub-dash.
4. Pull radio forward, disconnect the attached wire harness and antenna lead
and remove radio.
DASH DISASSEMBLY
2012-14 TOYOTA YARIS
KIT ASSEMBLY
FOR ISO or DIN MOUNT APPLICATIONS SEE PAGE 1
REMOVE SHADED MOUNTING
TABS ON BOTH LEFT AND
RIGHT SIDES OF KIT


Produkt Specifikationer

Mærke: PAC
Kategori: Ikke kategoriseret
Model: TOYK969

Har du brug for hjælp?

Hvis du har brug for hjælp til PAC TOYK969 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret PAC Manualer

PAC

PAC CAM-GM51 Manual

11 Juli 2025
PAC

PAC TY1A-RS Manual

11 Juli 2025
PAC

PAC SR-F15009HX Manual

10 Juli 2025
PAC

PAC SRK-RAM13HX Manual

10 Juli 2025
PAC

PAC AAI-TY3 Manual

30 Juni 2025
PAC

PAC SRK-GM14HX Manual

10 Marts 2025
PAC

PAC C2A-CHY Manual

19 Februar 2025
PAC

PAC MCI-FD22 Manual

19 Februar 2025
PAC

PAC GM6A-RST Manual

19 Februar 2025
PAC

PAC SWI-X Manual

19 Februar 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer