Pro1 T805 Manual

Pro1 Termostat T805

Læs gratis den danske manual til Pro1 T805 (6 sider) i kategorien Termostat. Denne vejledning er vurderet som hjælpsom af 3 personer og har en gennemsnitlig bedømmelse på 4.0 stjerner ud af 2 anmeldelser. Har du et spørgsmål om Pro1 T805, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/6

Installation Manual

Pro1 Technologies

Toll Free: 888-776-1427

Web: www.pro1iaq.com

Hours of Operation: M-F 9AM - 6PM Eastern

Thermostat Application Guide

Description

Gas or Oil Heat

Electric Furnace

Heat Pump (No Aux. or Emergency Heat)

Heat Pump (With Aux. or Emergency Heat)

Multi-Stage Systems

Heat Only Systems

Cool Only Systems

Millivolt

Yes

Power Type

Battery Power

Hardwire (Common Wire)

Hardwire (Common Wire) with

Battery Backup

Table of Contents

Installation Tips

Thermostat Quick Reference

Wiring

Wiring Diagrams

Technician Setup Menu

Programming

Features

Specications

Page

A trained, experienced

technician must install this

product.

Carefully read these

instructions. You could damage

this product or cause a

hazardous condition if you fail

to follow these instructions.

Una version en espanol de este

manual se puede descargar en

la pagina web de la compania.

U.S. Registered Trademark. Patents pending

5-8

13-17

2-4

Yes

Mount Thermostat

Align the 4 tabs on the subbase with

corresponding slots on the back of the

thermostat, then push gently until the

thermostat snaps in place.

Installation Tips

Note: To ensure a solid t between the

thermostat and the subbase:

1. Mount subbase to a at wall

2. Use screws provided

3. Drywall anchors should be ush with the wall

4. Wires should be pushed into the wall

Installation Tips

The thermostat should be installed approximately 4 to 5 feet above the

oor. Select an area with average temperature and good air circulation.

• Close to hot or cold air ducts

• That are in direct sunlight

• With an outside wall behind the thermostat

• In areas that do not require conditioning

• Where there are dead spots or drafts (in corners or behind doors)

• Where there might be concealed chimneys or pipes

Wall Locations

Pick an installation location that is easy for the user to access. The temperature

of the location should be representative of the building.

Installation Tip

Do not install thermostat in these locations:

Installation Tips

18-22

Vertical Mount

Horizontal Mount

For horizontal mount put one screw on

the left and one screw on the right.

All of our products are mercury free. However, if the product you are

replacing contains mercury, dispose of it properly. Your local waste

management authority can give you instructions on recycling and

proper disposal.

Mercury Notice

Failure to disconnect the power before beginning to install this product

can cause electrical shock or equipment damage.

Installation Tip: Electrical Hazard

For vertical mount put one screw on

the top and one screw on the bottom.

Subbase Installation

11-12

9-10

P.O. Box 3377

Springeld, MO 65808-3377

Rev. 1915

T805

Terminal Designations

This thermostat is shipped from the factory to operate a conventional heating

and cooling system. This thermostat may also be congured for a heat pump

system.

Wiring

Terminal

1 Heat 1 Cool

Conventional

System

Transformer power

(cooling)

Transformer power

(heating)

Transformer

common

Fan relay

Heat Relay

Compressor

Relay

Wiring

Caution:

Electrical Hazard

All components of the control

system and the thermostat

installation must conform to

Class II circuits per the NEC Code.

Warning:

Do not overtighten terminal

block screws, as this can

damage the terminal block.

A damaged terminal block

can keep the thermostat

from tting on the subbase

correctly or cause system

operation issues.

Installation Tip

Max Torque = 6in-lbs.

Wiring

If you are replacing a thermostat,

make note of the terminal

connections on the thermostat that

is being replaced. In some cases

the wiring connections will not be

color coded. For example, the

green wire may not be connected

to the terminal.G

Loosen the terminal block screws.

Insert wires then retighten the

terminal block screws.

Place nonammable insulation into

the wall opening to prevent drafts.

Wiring Tips

C Terminal

The C (common wire) terminal does

not have to be connected when the

thermostat is powered by batteries.

Wire Specications

Use shielded or non-shielded 18-22

gauge thermostat wire.

Failure to disconnect the power

before beginning to install this

product can cause electrical shock

or equipment damage.

Thermostat Quick Reference

Displays the current room temperature

Time and day of the week

Setpoint: Displays the user selectable setpoint temperature.

Hold: is displayed when the thermostat program is permanently overridden.

System Operation Indicators:

If these or the Fan indicator are ashing, it means that the system is in a

delay of some type (compressor delay, cooling fan delay, staging delay).

Low Battery Indicator: Replace batteries when this indicator is shown.

Program Menu Options: Show dierent options during programming.

Program Time Periods - Residential: Uses 4 time periods - WAKE, RETURN,

LEAVE & SLEEP.

Getting to know your thermostat

Thermostat Quick Reference

Battery Installation

Battery installation is recommended even if the thermostat is

hardwired (C terminal connected). When the thermostat is hardwired

and batteries are installed, the thermostat will activate a compressor

delay of 5 minutes when it detects a power outage from the hardwired

power supply.

Important:

High quality alkaline batteries are recommended.

Rechargeable batteries or low quality batteries

do not guarantee a 1-year life span.

Insert 2 AA Alkaline batteries

(included). High quality alkaline

batteries are recommended.

Simple operating instructions

are found on the back of the

battery door.

To release battery cover press nger bevel

on the left side and lift the cover to access

batteries.

Keypad Lockout: Lock the thermostat

N/A

Energy Ecient Globe: Indicates ecient setpoint temperature.

N/A

1 Heat 1 Cool

Heat Pump

System

Transformer power

(cooling)

Transformer power

(heating)

Transformer

common

Changeover valve

energized in cooling

Changeover valve

energized in heating

Fan relay

N/A

1st Stage of heat

and cool

Produkt Specifikationer

Mærke:	Pro1
Kategori:	Termostat
Model:	T805

Har du brug for hjælp?

Hvis du har brug for hjælp til Pro1 T805 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Termostat Pro1 Manualer

20 August 2025

20 August 2025

20 August 2025

20 August 2025

20 August 2025

20 August 2025

20 August 2025

20 August 2025

20 August 2025

20 August 2025

Termostat Manualer

Nyeste Termostat Manualer

Vimar 32041.C Manual

20 August 2025

Heatit S-Control2 Manual

19 August 2025

Kidde CV3202 Manual

18 August 2025

Mueller GS 10.00 knx Manual

18 August 2025

Mueller GS 30.10 knx Manual

18 August 2025

Mueller GS 20.00 knx Manual

18 August 2025

Mueller TS 30.10 knx Manual

17 August 2025

Nest Learning Thermostat 4th Gen Manual

15 August 2025

Honeywell RTH9580WF1005 Manual

14 August 2025

Honeywell YCT30A1003 Manual

14 August 2025